Project Ideas

STEP 5
Place a 14” section of black pipe over each rod. Then, using the holes in a
second panel, place the panel down over the rods (top photos). Drop a
washer over each and thread a nut all the way down (middle photos),
Tighten lightly with a wrench. NOTE: Before tightening, use a level to
ensure each pipe is vertically straight and hold in place (bottom photo).
page 4 of 7
STEP 6
Place each 7” piece of black pipe over each rod, then place the last
panel down over the rods (top photos below). Drop a washer over each
rod and tighten a nut to each (bottom photos), NOTE: Before tighten-
ing completely, use a level to ensure each pipe is vertically straight.