Project Ideas

STEP 4
Thread one nut about 1-1/2” up each threaded rod and follow with a
washer (top left photo).
Insert the short end of the rod through each of your bored holes (top
right photo),
Add a washer and thread a nut flush to the end of each rod (middle
photo).
Stand your project upright on a flat surface and tighten the four top
nuts using a pair of standard adjustable wrenches — one to hold the
bottom nut in place and one to tighten the top nut. Check for level
and adjust nut heights if necessary (bottom photos).
page 3 of 7