Project Ideas

STEP 2
From the short ends of each panel, measure and mark 3-3/8” in and
2-1/8” down (top-row photos).
Using a 7/16” spade bit, center carefully and drill through-holes at each
of your 12 marks (bottom-row photos).
STEP 3
Sand your panels with either sand paper or a power sander and wipe
clean (top left photo below).
If you wish, spray one or two coats of clear polyurethane, stain or paint
your panels following the manufacturer’s instructions (top right photo).
Use denatured alcohol to clean all pipes and fittings with a clean rag
(bottom photo).
TOOLS NEEDED
Tape measure
Pencil
Table saw if making your own cuts
Power drill and bit set
7/16” spade bit
Sand paper or power sander
Standard adjustable wrench set
Level
2 – 12” pipe wrenches
PROJECT COST
About $170
ESTIMATED TIME
2 hours
DIY PROJECT PLANS
CONT.
page 2 of 7