User's Manual

13
Program Setup "Quick Set"
The program function guides the
user through the setup for each
of the time settings (Wake, Away,
Home and Sleep), based on the
selected zones to set the desired
temperatures.
!
NOTE: It is recommended that
the main overall programming be
done rst - i.e. bedrooms during
the work week and program the
entire day, then perform another
setup for another zone to speed
up the programming. After the
main programming is complete,
ne tuning can be done on a
single day, zone or event basis,
by holding down the day or event
icon for 3 seconds.
!
NOTE: There is a blank setting
table at the back of this manual to
assist with ensuring that all of the
required events and zones have
been setup to the desired times
and temperatures.
CAUTION: Always press the
icons with a blunt object. Sharp
objects like pen and pencil points
may damage the touch screen.
1. Press the icon to start
the setup. The rst setting will
be for the Wake Event
. The zone icons will begin to
ash.
!
NOTE: At any time, pressing
the icon will return to the previ-
ous step. If the icon is held for
3 seconds it will return to the main
operating screen.
2. Select the zone(s) that the
settings are going to be ap-
plied.
!
NOTE: As each zone is se-
lected it will become solid and the
remaining zones will continue to
ash.
3. Press the icon.
4. The day icons will begin to
ash.
5. Select the days that the set-
tings are going to be applied.
!
NOTE: As each day is se-
lected it will become solid and the
remaining days will continue to
ash.
6. Press the icon.
7. Using the and icons on
either side of the time set-
ting, set the time for the Wake
event to occur.
Program Schedule Setup