User's Manual

19
Operation
zone or multiple zones needs to
be adjusted for the remainder of
the current event a Temporary
Temperature Change can be
done.
1. Select the Zone to which the
temperature change will be
applied.
2. Using the and icons,
adjust the set point to the
desired temperature.
3. Select additional Zones if
needed.
!
NOTE: All of the settings will
adjust to these programmed set-
tings at the next event for each of
the specied zones.
Indenite Temperature Changes
If the temperature in a particular
zone or multiple zones needs
to be adjusted for an indenite
period of time, an Indenite Tem-
perature Hold can be done.
1. Select the Zone to which the
temperature hold will be ap-
plied.
2. Using the and icons,
adjust the set point to the
desired temperature.
3. Press and hold the
Icon.
4. Select additional Zones if
needed.
5. Press the icon to save the
changes and revert back to
operation mode.
!
NOTE: To exit the hold mode,
the user can press the icon.
This will remove all holds that
have been applied.
Factory Reset
If the programmed settings need
to be adjusted signicantly, it is
possible to Reset the controller
back to the Factory settings.
1. Press and hold the
icon for 10 seconds.
2. Follow the prompts to con-
rm the day, time, and unit of
measurement.