Installation manual

10
Figure 3: Suggested heat pump layout and minimum access and air flow clearance dimensions (in mm)
2.1.3 H EAT P UMP P LACEMENT AND F IXING
• Approximately 2 litres of condensate water are drained from the system every time a defrost cycle occurs
(approximately once every hour in cold and humid weather). Therefore, it is essential that the condensate pipe is
fed into a drain or soak away to allow for safe disposal of the excess water, away from footpaths or patios.
• The condensate drain pipe is coiled up inside the heat pump for protection during transportation. In order to access
this for installation, the panels will need to be removed (see section 3.3.1).
• The removal of condensate must be secured and the condensate pipe must be kept free from debris and frost. The
pipe should be prevented from exposure to the elements, as this may contribute to freezing issues. Freezing of this
pipe due to incorrect installation can result in irreparable damage and void warranty.
• The condensate pipe should not run into sewer pipe unless a suitable trap is installed, as fumes may travel into the
heat pump and cause corrosion to the evaporator coil.
• The heat pump must be fixed onto a level, stable base that is capable of withstanding the unit’s weight of 110-130kg
(depending on model), with a minimum distance of 50mm around all sides of the heat pump. It can be secured on
the inside of the heat pump with M10 anchor bolts, by removing the outer panels and using the fixing holes shown in
figure 3.