Installation manual

13
Figure 19(a): Initial Installer Menu screen
Figure 17: Home Screen
INFORMATION
MENU
6 Getting Started
When switching on the heat pump for the first time,
and after the start up sequence, you will be greeted
by the home screen, shown in figure 17.
If the heat pump is already switched on but you wish
to make changes to the settings, you may need to
press confirm in order to go from the screensaver to
the home screen.
To access the Installer Menu, you must select the
information menu, which can be done by turning the
rotary dial to navigate, then pressing it in to select an
option. Once you have entered the information menu,
you must select ‘Login’, as shown in figure 18.
NOTE: You will not be able to access any other
options on the home screen, except the information
menu, until the heat pump has been commissioned.
When using the ‘Login’ function, input the access code
supplied to you during training (22 - Installer) by
turning the dial to scroll through numbers, then
pressing in the dial to select as before. You will then
need to input 55 (commissioning menu code) to bring
up the installer menu.
When you enter the installer menu, you will see the
option for ‘Language Selection’, as shown in figure 19
(a). As you progress through the set up process,
other options will become available on this menu.
Select the ‘Language Selection’ option, which will
bring you to the ‘Start Guide’ screen (shown in figure
19(b)). Selecting ‘UK’ will bring you back to the
Installer Menu, which will now display the
‘Commissioning’ option (shown in figure 19(c)).
Select ‘Commissioning’ to begin and follow the step
by step guide on the user interface, which will take
you through all necessary steps of commissioning.
Instructions for commissioning are also detailed in
section 7.
Figure 19(b): Start Guide screen
Figure 18: Information Menu showing Login option