Owner’s Manual Model Numbers: BF362SD BF392SD Quality checked by: Serial Number Model Number Part Number Valued Customer, Thank you and congratulations for purchasing a Dimplex electric fireplace. Over the years, valuable memories will occur around the warmth and comfort of your fireplace. Thank you for allowing our product to be the backdrop for those special moments.
QUICK REFERENCE GUIDE 1. Prior to the first use of the fireplace verify the following: • Are the circuit breakers for the socket the unit uses on? • Are the light bulbs in your fireplace loose? (to check, follow the instructions for replacing the light bulbs under the Maintenance section of this manual. 2. The heater on your fireplace may emit a slight, harmless odor when first used. This odor is a normal condition caused by the initial heating of internal heater parts and will not occur again.
CONTENTS PAGE 1 Important Instructions PAGE 3 Operation PAGE 5 Maintenance PAGE 7 Warranty
IMPORTANT INSTRUCTIONS Retain This User’s Guide For Future Reference When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Always use a certified electrician for installation. 2. Read all instructions before using this fireplace. 3. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, illness or death. NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules.
Operation FIGURE 1 Remote Control NOTE: If the fireplace turns on or off without input from the hand held remote or does not respond to the hand held remote control, see section A. Remote Control Initialization. If the unit continues to operate erratically contact customer service as a new hand held with a different frequency may be required. Off Button On Button The Optiflame fireplace is supplied with a radio Frequency remote control.
remote control transmitter. (FIGURE 1) This will synchronize the remote control transmitter and receiver. B. Remote Control Usage The remote control operates the fireplace levels sequentially. The level is increased every time the On button on the transmitter is pressed.The fireplace can be turned off at any point by pressing the Off button on the remote control transmitter. Level 1: The flame effect is turned on and the first red indicator light is activated.
heater control switch is activated. The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again. Resetting The Temperature Cutout Switch The heater on this fireplace is protected with a safety device to prevent overheating. Should the heater overheat, an automatic cutout will turn the heater off and it will not come back on without being reset.
GE 60BC or Philips 60CTC. Do not exceed 60 Watts per bulb. Tool Requirements: Slot Screw Driver To access the light bulb area: 1. Open steel curtain (remove glass doors if applicable). The FIGURE 4 bulbs can be accessed from either side of the fireplace. 2. Remove two screws on log bracket and remove log plate (FIGURE 4). 3.
To remove fingerprints or other marks, the mirror can be cleaned with a damp cloth using good quality household glass cleaner. The mirror should be completely dried with a lint free cloth or paper towel. CAUTION: Do not use abrasive cleaners on mirror surface or spray liquids directly onto any surface. Accessories Please contact your local dealer for genuine Dimplex accessories. Example: Glass door kits, brass trim, cabinets designed to fit your Optiflame fireplace.
and trims and the limited 1 year warranty period for fireplace surrounds (mantels) and trims also applies to any implied warranties that may exist under applicable law. Some jurisdictions do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to the purchaser. What this limited warranty does not cover This limited warranty does not apply to products that have been repaired (except by Dimplex or its authorized service representatives) or otherwise altered.
will not be responsible for, and this limited warranty shall not include, any expense incurred for installation or removal of the surrounds (mantels) or trims or any part thereof (or any replacement product or part) including, without limitation, all shipping costs and transportation costs to and from the authorized dealer’s or service agent’s place of business and all labour costs. Such costs shall be the purchaser’s responsibility.