Owner’s Manual Model BF45DXP BF39STP/DXP BF33STP/DXP IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this fireplace. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.
Table of Contents Welcome & Congratulations. . . . . . . . . . . . . . . . . . . . 3 IMPORTANT INSTRUCTIONS. . . . . . . . . . . . . . . . . . 4 Fireplace Installation . . . . . . . . . . . . . . . . . . . . . . . . . 5 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Warranty . . . . . . . . . . . . . . . . . . . . . . . .
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: ① Read all instructions before using this appliance. ② This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation.
IMPORTANT INSTRUCTIONS manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. ⑫ Do not burn wood or other materials in this fireplace. ⑬ Do not strike fireplace glass. ⑭ Always use a certified electrician for installation. ⑮ Disconnect all power coming to fireplace at main service panel before performing any cleaning, or maintenance.
Operation Figure 1 Overheat Indicator C. Voltage Selector Switch B. Mode Selector Switch A. On/Off Switch Manual Controls WARNING: This electric firebox must be properly installed before it is used. Manual Controls (Figure 1) The controls for the Electric Fireplace are located at the bottom right hand corner of the unit. CAUTION: Ensure that the Voltage Selector switch is set to the appropriate voltage (115V or 230V) A. On/Off Switch The on/off switch energizes the firebox and flame. B.
Operation back on without being reset. It can be reset by switching the On/ Off switch to OFF and waiting 5 minutes before switching it to ON. The overheat cutout will be triggered if the filter is dirty. Follow filter maintenance. CAUTION: If you need to continuously reset the heater, disconnect power and call Dimplex customer service at (1-888-346-7539). Remote Controls An optional remote control can be purchased to operate the fireplace - BFRC-KIT.
Maintenance WARNING: Disconnect power and heater has cooled before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. ! NOTE: The fireplace should not be operated with an accumulation of dust or dirt on or in the unit, as this can cause a build up of heat and eventual damage. For this reason the heater must be inspected regularly, depending upon conditions and at least at yearly intervals.
Maintenance Figure 3 Back Ledge Rear Tab Log Ember bed Side Section Front Edge Figure 4 LED Wire Harness leases from the ledge located at the bottom of the partially reflective glass (Figure 3). ! NOTE: Log set fits tightly into firebox, some force may be necessary to remove. 4. Set logset in front of firebox. 5. Disconnect the logset LED wire harness from unit (Figure 4). 6. Examine the bulbs to determine which bulbs require replacement. 7. Unscrew bulbs counter clockwise. 8. Insert new bulbs. 9.
Maintenance Figure 6 Purifire™ Filter Filter Bracket Mounting Screws 1. Remove the 2 mounting screws from the air filter bracket. 2. Slide forward to remove the air filter bracket assembly from the firebox. 3. Slide filter out of air filter bracket. 4. Reassemble in reverse order as above. ! NOTE: If after market air filter is used ensure it is installed according to the manufacturers recommended instructions.
Accessories Please contact your local dealer for genuine Dimplex accessories. Example: glass door kits, brass and stainless steel trims, remote control kits, plug kits, and cabinets designed to fit your fireplace.
Warranty (mantels) and trims and the limited 1 year warranty period for fireplace surrounds (mantels) and trims also applies to any implied warranties that may exist under applicable law. Some jurisdictions do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to the purchaser.
Warranty then-current rates for such services. Dimplex will not be responsible for, and this limited warranty shall not include, any expense incurred for installation or removal of the surrounds (mantels) or trims or any part thereof (or any replacement product or part) including, without limitation, all shipping costs and transportation costs to and from the authorized dealer’s or service agent’s place of business and all labour costs. Such costs shall be the purchaser’s responsibility.
Replacement Parts BF33STP BF33DXP BF39STP BF39DXP BF45DXP Log Set Assembly 0438200300RP 0439230100RP 0438550200RP 0439070100RP Flicker Rod 5900081000RP 5900080900RP Grommet 8500000600RP Flicker Motor 6901811200RP Blower Motor 5300160100RP Heater Element 2200510100RP Cutout 2300200900RP 2300200800RP On/Off Switch 2800070400RP 3-Position Switch 2800070800RP Partially Reflective 5900161000RP 5900161100RP 5900160600RP 5900160700RP 5900160400RP Glass Extrusion NA 0438650100RP Steel Curtain 8800240403RP 880024010
