BF45DXP, BF39STP, BF39DXP, BF33STP, BF33DXP Built in Firebox Owner's Manual

7
Operation
back on without being reset. It
can be reset by switching the On/
Off switch to OFF and waiting
5 minutes before switching it to
ON. The overheat cutout will be
triggered if the lter is dirty. Follow
lter maintenance.
CAUTION: If you need to
continuously reset the heater, dis-
connect power and call Dimplex
customer service at
(1-888-346-7539).
Remote Controls
An optional remote control
can be purchased to operate
the replace - BFRC-KIT. This
will allow the user the ability to
toggle through the three stages
of operation: Flames, Flames and
Purire
TM
, and Flames/ Purire
TM
/
Heat, with a remote control.
Wall Mounted Controls
The replace can be installed
with wall mounted controls. These
controls include wall switches and
thermostats. (see individual instal-
lation guides for details)
1. Wall Mounted Switches
This model may be installed
so that a wall mounted switch
energizes the rebox and
ame, (On/Off Switch must
be in the ON position). A
wall mounted switch may
also be used to override the
ame image, (On/Off Switch
must be in the ON position
in coordination with any
main power wall mounted
switch). A wall mounted
switch may also be used
to override the heater/Puri-
re
TM
option (Mode Selector
Switch must be in the “=”
position).
2. Wall Mounted Thermostat
This unit may be installed so
that a wall mounted ther-
mostat can adjust the heat
temperature to your individual
requirements. Please refer
to thermostat manufacturers
operation Instructions. Mode
Selector Switch must be
set to “=” for thermostat to
control heater/Purire
TM
.
3. Wall Mounted Remote Controls
(WRCPF-KIT)
Dimplex manufactures a
optional wall mounted remote
control which allows the user
to fully control the replace
from a central location with
the added functionality of a
built in thermostat.