Owner’s Manual Model BF45DXP BF39STP/DXP BF33STP/DXP IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this fireplace. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.
Table of Contents Welcome & Congratulations. . . . . . . . . . . . . . . . . . . . 3 Important Instructions. . . . . . . . . . . . . . . . . . 4 Fireplace Installation . . . . . . . . . . . . . . . . . . . . . . . . . 5 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Warranty . . . . . . . . . . . . . . . . . . . . . . . .
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
Important Instructions When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: ① Read all instructions before using this appliance. ② This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation.
Important Instructions ⑬ Disconnect all power coming to fireplace at main service panel before performing any cleaning, or maintenance. ⑭ When transporting or storing the fireplace, keep in a dry place, free from excessive vibration and store as to avoid damage. WARNING: Remote control contains small batteries. Keep away from children. If swallowed, seek medical attention immediately.
Operation Figure 1 Overheat Indicator C. Voltage Selector Switch B. Mode Selector Switch A. On/Off Switch Manual Controls The controls for the Electric Fireplace are located at the bottom right hand corner of the unit. Manual Controls (Figure 1) CAUTION: Ensure that the Voltage Selector switch is set to the appropriate voltage (115V or 230V) A. On/Off Switch The on/off switch energizes the firebox and flame. B.
Operation 1. Wall Mounted Switches This model may be installed so that a wall mounted switch energizes the firebox and flame, (On/Off Switch must be in the ON position). A wall mounted switch may also be used to override the flame image, (On/Off Switch must be in the ON position in coordination with any main power wall mounted switch). A wall mounted switch may also be used to override the heater/PurifireTM option (Mode Selector Switch must be in the “=” position). 2.
Maintenance WARNING: Disconnect all power coming to fireplace at main service panel before attempting maintenance or cleaning to reduce risk of fire, shock or damage to persons. CAUTION: Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental burning of skin. Tool Requirements: Phillips screwdriver Light Bulb Replacement: Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears.
Maintenance Figure 3 Back Ledge Rear Tab Log Ember bed Side Section Front Edge Figure 4 LED Wire Harness 4. Set logset in front of firebox. 5. Disconnect the logset LED wire harness from unit (Figure 4). 6. Examine the bulbs to determine which bulbs require replacement. 7. Unscrew bulbs counter clockwise. 8. Insert new bulbs. 9. Re-connect the logset LED wire harness to the unit. 10.
Maintenance Figure 6 Purifire™ Filter Filter Bracket Mounting Screws from the firebox. 3. Slide filter out of air filter bracket. 4. Reassemble in reverse order as above. ! NOTE: If after market air filter is used ensure it is installed according to the manufacturers recommended instructions. Mirror Cleaning The mirror is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc., the mirror surface may collect dust particles.
Warranty Two Year Limited Warranty Products to which this limited warranty applies This limited warranty applies to the following models of your newly purchased Dimplex electric fireplace BF45DXP, BF39DXP, BF39STP, BF33DXP, BF33STP and to newly purchased Dimplex fireplace surrounds (mantels) and trims.
Warranty service representatives) or otherwise altered. This limited warranty does further not apply to defects resulting from misuse, abuse, accident, neglect, incorrect installation, improper maintenance or handling, or operation with an incorrect power source. What you must do to get service under this limited warranty Defects must be brought to the attention of Dimplex Technical Service by contacting Dimplex at 1-888-DIMPLEX (1-888-346-7539), or 1367 Industrial Road, Cambridge Ontario, Canada N1R 7G8.
Warranty dealer’s or service agent’s place of business. On-site or in-home services for surrounds (mantels) and trims may be performed at the purchaser’s specific request and expense at Dimplex’s thencurrent rates for such services.
Replacement Parts BF33STP BF33DXP BF39STP BF39DXP BF45DXP 0439070100RP Log Set Assembly 0438200300RP 0439230100RP 0438550200RP Flicker Rod 5900081000RP 5900080900RP Grommet 8500000600RP Flicker Motor 6901811200RP Blower Motor 5300160100RP Heater Element 2200510100RP Cutout 2300200900RP 2300200800RP On/Off Switch 2800070400RP 3-Position Switch 2800070800RP Partially Reflective 5900161000RP 5900161100RP 5900160600RP 5900160700RP 5900160400RP Glass Extrusion NA 0438650100RP Steel Curtain 8800240403RP 880024010
