Remote Installation Guide

Remote Control Usage
The remote control operation can
be adjusted, depending on the
season and desired effects, by
toggling the main mode selector
switch built into the replace.
The position of the switch will
dictate the available functions that
the remote transmitter will cycle
through.
A. On Button
Pressing this button toggles
sequentially through the three
levels of the replace.
Mode Selector Set at “O”: •
Only Flame Effect at all 3
levels.
Mode Selector Set at “--”: •
Pressing once activates Level
1 - ame effect only, two and
three times activates Level 2 -
ame effect and Purire™.
Mode Selector Set at “=”: •
Pressing once activates Level
1 - ame effect only, twice
activates Level 2 - ame
effect and Purire™, three
times activates Level 3 -
ame effect, Purire™ and
heat.
B. Off Button
Pressing this button at any time
will shut the unit off.
C. Manual Selection Switch
Switches the operation of the
replace between the different
modes of the replace:
OFF (center): Makes the unit •
inoperable.
MANUAL (top): All functions •
of the replace are controlled
by the On and Off buttons as
described above (A, B).
REMOTE (bottom): All •
functions of the replace are
controlled by the Remote
Control.
D. LED Indicators
Depicts which of the three (3)
levels the replace is currently
operating at: Level 1 - , Level
2 - or Level 3 - .
Operation
8
ON
Button
OFF
Button
Battery
Battery
Cover
Figure 7
Remote Control Transmitter