Assembly Instructions

BFPLUG
1. Locate the switch on the top corner of the unit.
2. Change the switch from 230 volt to 115 volt configuration.
3. Loosen the screw securing the junction box cover and remove the cover.
4. Pull out the four wires marked L1, L2, N, and G.
5. Connect with the supplied wire connectors the black L1 wire from the unit to
the non ribbed L1 wire from the power cord. Connect with the supplied wire
connectors the red L2 and white N wires from the unit to the ribbed or neutral
from the power cord. Connect a wire connector to the green ground wire from
the unit.
6. Ensure that all wire connections are tight.
7. Install the junction box cover and tighten the screw
.
WIRE CONNECTORS
CORDSET JUNCTION BOX COVER
RIBBED WIRE
1367 Industrial Road, Cambridge, Ontario N1R 7G8 Telephone: [phone] fax: [phone]
7206050100