Service Manual

12 www.dimplex.com
TERMINAL BLOCK REPLACEMENT
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required: Phillips head screwdriver.
CAUTION: Follow “Preparation for Service” instructions
before proceeding.
1. In the bottom right hand of the unit, remove both of the
access cover. (Figure 11)
2. Remove the 2 retaining screws (Figure 12) on the
bracket that the icker motor is mounted to remove the
assembly.
3. Carefully remove the entire assembly.
!
NOTE: It may be easier to remove the icker rod (see
step 2 of Flicker Motor Replacement) to allow the whole
assembly to be removed.
4. Remove the wires from the terminal block by loosen-
ing the small Philips screws holding each wire in place
then gently pulling the wires out of the terminal block -
noting their original locations.
5. Remove the 2 screws holding the terminal block to the
mounting bracket. Gently pull the terminal block away
from the bracket.
6. Properly orient the new terminal block onto the bracket
and re-attach with the 2 mounting screws.
7. Reassemble in the reverse order as above.
CAUTION: When removing and replacing the icker
motor try to keep any slight bending of the icker rod
minimal so as to not damage it. If icker rod is damaged, it
should be replaced to ensure proper operation.
CAUTION: When re-installing, be sure the wires are
guided and tucked into the proper openings along the right
side so they are not pinched and allows enough space to
reinstall the panels.
LED LIGHT STRIPS REPLACEMENT
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required: Phillips head screwdriver
Wire Snips
CAUTION: Follow “Preparation for Service” instructions
before proceeding.
1. Remove the decorative glass ember-bed pieces from
the media tray, which lies along the bottom of the interi-
or Partially Reective Glass. A medium sized container
such as a bucket or a box will be needed to keep the
glass ember-bed pieces together.
!
NOTE: Try to ensure the pieces do not get pushed or
wedged underneath the Partially Reective Glass. They
may obstruct the ease of removing the Partially Reective
Glass from the replace.
2. Remove the Partially Reective Glass retaining brack-
ets by removing the 2 screws on each brackets; (2
brackets in total), located on the left and right side of
the Partially Reective Glass. (Figure 15)
3. Remove the 2 screws, that secure the controls assem-
bly (Figure 9), located at the top of the mirror on the
right side of the unit.
4. Slide the controls assembly out toward the front of the
unit.
Figure 14
Retaining Brackets
A
B
C
Figure 13