Service Manual
Table Of Contents
- OPERATION
- Maintenance
- EXPLODED PARTS DIAGRAM
- WIRING DIAGRAM
- MOD 0-A
- MOD B
- Preparation for service
- Instructions for removing from wall
- On/Off Switch Replacement
- Remote Switchboard Replacement
- Remote Control Receiver Replacement
- LED Driver Board Replacement
- Flicker Motor/ Flicker Rod Replacement
- Terminal Block Replacement
- LED Light Strips Replacement
- High Temperature Cutout Replacement
- Element Replacement
- Blower/fan Replacement
- TROUBLESHOOTING GUIDE
15
unit.
CAUTION: Ensure that the assembly is removed care-
fully, ensuring that no wires are caught or over strained.
9. Remove the 2 screws, that secure the cover panel
(Figure 15), located at the top of the mirror on the left
side of the unit.
10. Remove the two screws on either side of the heater/
blower assembly and gently lower the assembly so that
the top can be viewed.
CAUTION: When removing the blower assembly
mounting screws, support the assembly to prevent any
damage to the unit.
11. Remove the 6 screws (3 sets) that secure the blower to
the assembly (Figure 16).
12. Disconnect the wiring connections noting their original
locations.
!
NOTE: Using a ๎at head screwdriver gently pry between
the end of the connectors and the blower/fan to release the
wires.
13. Properly orient the new blower/fan assembly and con-
nect all of the wiring connections.
14. Reassemble in the reverse order as above.