Service Manual
Table Of Contents
- OPERATION
- Maintenance
- EXPLODED PARTS DIAGRAM
- WIRING DIAGRAM
- MOD 0-A
- MOD B
- Preparation for service
- Instructions for removing from wall
- On/Off Switch Replacement
- Remote Switchboard Replacement
- Remote Control Receiver Replacement
- LED Driver Board Replacement
- Flicker Motor/ Flicker Rod Replacement
- Terminal Block Replacement
- LED Light Strips Replacement
- High Temperature Cutout Replacement
- Element Replacement
- Blower/fan Replacement
- TROUBLESHOOTING GUIDE
4 www.dimplex.com
MAINTENANCE
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of re, elec-
tric shock or damage to persons.
!
NOTE: The replace should not be operated with an ac-
cumulation of dust or dirt on or in the unit, as this can cause
a build up of heat and eventual damage. For this reason
the heater must be inspected regularly, depending upon
conditions and at least at yearly intervals.
Partially Reective Glass Cleaning
The partially reective glass is cleaned in the factory dur-
ing the assembly operation. During shipment, installation,
handling, etc., the partially reective glass may collect dust
particles; these can be removed by dusting lightly with a
clean dry cloth.
To remove ngerprints or other marks, the partially reec-
tive glass can be cleaned with a damp cloth. The partially
reective glass should be completely dried with a lint free
cloth to prevent water spots. To prevent scratching, do not
use abrasive cleaners.
Fireplace Surface Cleaning
Use only a damp cloth to clean painted surfaces of the
replace. Do not use abrasive cleaners.
Servicing
Except for installation and cleaning described in this manu-
al, an authorized service representative should perform any
other servicing.