Owner`s manual

16 www.dimplex.com
Operation
control buttons.
In “ OFF ” mode, power to all
functions is cut off.
When in “ REMOTE ” mode, the
replace's levels of operation are
controlled by the ON and OFF
buttons on the remote control.
C. Manual Control Buttons
The Manual Control Buttons oper-
ate the replace levels. The level
is increased every time the “I” but-
ton is pressed the unit will cycle
the levels through sequentially
(from off): ames only; to ames
and heat.
!
NOTE: There is a third level
that does not change the output,
before cycling back to ame only.
The replace can be turned off
at any point by pressing the “ O ”
button.
!
NOTE: The heater may emit
a slight, harmless odor when rst
used. This odor is a normal condi-
tion caused by initial heating of
internal heater parts and will not
occur again.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
replace off and it will not come
back on without being reset. It
can be reset by switching the On/
Off Switch to Off and waiting ve
minutes before switching the unit
back on.
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DIMPLEX
(1-888-346-7539).
Remote Control
The replace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 ft. (15.25 m), it
does not have to be pointed at the
replace and can pass through
most obstacles (including walls).
It is supplied with one of hundreds
of independent frequencies to
prevent interference with other
units.
!
NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out
from between the remote cas-
ing and battery cover (Figure
13).
Remote Control Usage
The remote control operates the