Cavendish CSH20, Chesford CSD20 08/50756/1 Issue 1 The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3 These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC
590 310 350 160 657 300 Min. 405 310 Fig.1 Fig.2 Fig.
Fig.5 Fig.4 Fig.6 Fig.7 Fig.8 Fig.
Fig.10 Fig.11 Fig.
Fig.13 Fig.14 Fig.15 Fig.16 Fig.17 Fig.
Dimplex Opti-myst Inset Fires Model: Cavendish CSH20 (Brass Inset), Chesford CSD20 (Titanium Inset) IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE Important Safety Advice: When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following: If the appliance is damaged, check with the supplier before installation and operation. Do not use outdoors.
Installation Instructions Before installing this appliance, we recommend that; 1. You have your chimney cleaned by a competent chimney sweep. 2. You block off the chimney flue. This procedure is important for the efficient operation of the heating unit and will also reduce heat loss up the chimney. Control Knob ‘C’:- Controls the intensity of the flame effect. Turning the control knob Clockwise increases the flame effect, turning the control knob Anti Clockwise will decrease the flame effect.
Battery Information. 1. Unclip the battery cover on the back of the remote control. (See Fig.7) 2. Install AAA batteries into the remote control. 3. Replace the battery cover. Discard leaky batteries. Dispose of batteries in the proper manner according to provincial and local regulations.
Cleaning. WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER. We Recommend cleaning the following components once every 2 weeks, particularly in hard water areas:Water Tank, Sump and Seal, Sump lid, Tank cap and seal, Air filter. For general cleaning use a soft clean duster – never use abrasive cleaners. To remove any accumulation of dust or fluff the soft brush attachment of a vacuum cleaner should occasionally be used to clean the outlet grille of the fan heater. Water tank 1.
Troubleshooting Symptom Cause Corrective Action The flame effect will not start. Mains plug is not plugged in. Check plug is connected to wall socket correctly. Switch A is in the ‘ON’ (I) position, but mode Switch B has not been pressed. (See Fig.2) Low water level. Press Switch B once for flame effect.(See Fig.2) Check ‘Low water level’ warning LED ‘E’ under canopy hood. (See Fig.2). If ‘ON’ fill water tank. Low voltage connector not connected properly. (See Fig.
.
Opti-myst is a trade mark of Dimplex UK Ltd This product is protected by one or more of the following patents : PCT/ EP2005/009774, PCT/ EP2007/002207, GB0717773.6, GB0717772.8, GB0717770.2, GB0809322.1The design of this product is protected by EU Design Rights Dimplex UK Limited Millbrook House Grange Drive Hedge End Southampton Hampshire. SO30 2DF www.dimplex.co.uk Republic of Ireland Tel. 01 8424833 [c]Dimplex UK Limited All rights reserved.
