Service manual

3
Operation
Electric Fireplace Manual Control
The manual controls for the unit are located behind the
control panel on the front of the rebox (Figure 1). A switch
is in the ON position when the side with the markings on it
(i.e. I, or II) is pushed in.
A - 3 Position On/Off Switch
(I) Manual mode
Controls the electricity supply to the heater and ame
manually.
(II) Remote mode
Allows the control of electricity supply to the heater and ame
through the use of the supplied remote control.
!
NOTE: This switch must be in the ON (I) position for
heater to operate with or without heat.
B - Low Heat Switch
(I) Provides 715 Watt heat output.
C - High Heat Switch
(II) Provides 1430 Watt heat output with Switch B.
!
NOTE: If Switches B and C are in the off position, only
the ame effect will turn on when Switch A is activated.
Remote Control
The replace is supplied with an integral on/off remote
control.
!
NOTE: Ensure that the replace’s 3 Position On/Off
Switch is set to the remote control setting (I.E.. II).
To operate: push ON button to turn replace on; push OFF
button to turn replace off (Figure 2).
!
NOTE: Remote control operates main power supply. Heat
must still be controlled by switches on replace.
Battery Installation/Replacement
1. Depress tab on the battery cover on the back of the
remote transmitter and remove battery cover (Figure 2).
2. Properly orientate and install one (1) 12 Volt (A23) battery
into the remote control.
3. Replace the battery cover.
Resetting The Temperature Cutoff Switch
Should the replace overheat, an automatic cut out will turn
the heater off and it will not come back on without being
reset. It can be reset by switching Switch A (Figure 1 A) to
OFF and waiting ve (5) minutes before switching the unit
back on.
CAUTION: If you need to continuously reset the heater,
unplug the unit and call Dimplex North America Limited at
1-888-346-7539 for technical support.
B
Figure 1
A
C
Manual Control
Switches
Control Panel
Figure 2
On
Button
Off
Button
Battery Cover
Battery