Grand Stove Noir RTOPSTV20GN Crème RTOPSTV20GC Rough RTOPSTV20GR 08/52687/0 Issue 0 The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3 These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC
Dimplex OPTIMYST Stove Introduction Thank you for choosing this Dimplex electric fire. Please read this information guide carefully to be able to safely install, use and maintain your product. Important Safety Advice When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following: 1. OVERHEATING WARNING: In order to avoid overheating, do not cover the heater.
The water tank, sump, sump lid, tank cap and air filters must be cleaned once every two weeks, particularly in hard water areas. The appliance should never be operated if the lamps are not working. The lamps should be regularly inspected as described under ‘Maintenance’ and ‘Changing lamps’.
Switch ‘B’:- Press once to turn on the flame effect. This will be indicated by an audible beep. Although the main lights operate immediately it will take a further 30 seconds before the flame effect starts. Press again to give flame effect and half heat. This will be indicated by two beeps. Press again to give flame effect and full heat. This will be indicated by three beeps. Press again to return to flame effect only. This will be indicated by one beep. Press to put fire in to standby mode.
Maintenance GENERAL TIPS Only use filtered tap water in this appliance. Always ensure that the appliance is sitting on a level surface. If you intend not using the appliance for longer than 2 weeks, remove and empty the sump and water tank. Once installed, never move this appliance or lay on its back, without draining the water from sump and water tank. The appliance should never be operated if the lamps are not working. The lamps should be regularly inspected as described under ‘Changing lamps’.
5. Release the right sump locking tabs by turning 90º. This allows the sump to be lifted completely from its location. 6. Gently lift up the sump, taking care to keep level so as not to spill any water. Sit the assembly in the sink. 7. Release the left sump locking tabs by turning 90º, then lift off the Nozzle. (See Fig.3) 8. Lift out the transducer and carefully tilt, as shown, so that the liquid drains out of the sump. (See Fig.13) 9.
PATENT / PATENT APPLICATION Products within the Optimyst range are protected by one or more of the following patents and patent applications: Great Britain GB 2402206, GB 2460259, GB 2460453 , GB 2418014, GB 2465738, GB 2449925, GB 2465537 , GB 2455277 , GB1020534.2, GB1020537.5, GB1110987.3 United States US 7967690, US 2010299980, US 2011062250, US 2008028648, US 13/167,042 Russia RU2008140317 European EP 2029941, EP 2201301, EP 2315976, EP 1787063, EP07723217.1 , EP11170434.2, EP 11170435.
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig.
Fig. 5 Fig. 5a Fig. 5b Fig. 6 Fig. 7 Fig.
Fig. 9 Fig. 10 Fig. 11 Fig. 12 Fig. 13 Fig.
Fig. 15 Fig. 16 Fig.
OPTIMYST is a trade mark of GDC Group Ltd. GDC Group Ltd. MILLBROOK HOUSE GRANGE DRIVE HEDGE END SOUTHAMPTON TEL: 0844 879 3588 FAX: 0844 879 3583 WEBSITE: www.dimplex.co.uk Republic of Ireland Tel. 01 8424833 SO30 2DF c GDC Group Ltd, All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex. A division of GDC Group Ltd.
