MODEL: DC10RCDH / DC12RCDH INSTRUCTION MANUAL PORTABLE AIR CONDITIONER
IMPORTANT INFORMATION Carefully read this instruction manual before you install or use your portable air conditioner. Please retain this manual for product warranty and for future reference. CAUTION 1. Make sure the inlet and outlet vents are never blocked. 2. Ensure the appliance is on a stable, even surface when operating to avoid water leakage. 3. Do not operate this unit in an explosive or corrosive atmosphere. 4.
PACKAGE CONTENTS Portable air conditioner Remote control User manual Extendable window kit PARTS 1. Control panel 2. Remote control receiver 3. Adjustable air vent 4. Window kit adaptor 5. Exhaust hose 6. Hot air filter 7. Hot air inlet 8. Home for remote control 9. Hot air outlet 10. Water filler（for humidifying function） 11. Cool air filter 12. Cool air inlet 13. Water tank 14. Drain hole 15. Outlet grille (for heating and humidifying 16.
CONTROLS AND DISPLAY 1. POWER Press the POWER button to turn the unit "ON" or "OFF". ※ The portable air conditioner is fitted with a compressor delay protection circuit. This protects the unit from possible damage due to rapid starting and stopping of its compressor. Compressor operation begins 3 minutes after the unit is switched on or the mode is switched from dehumidify to air conditioning. 2. FUNCTION Press this key to select cooling, heating, dehumidifying or humidifying. ※ Humidifier: 1.
3. (TEMP+) In cooling mode, this button raises the set temperature by 1°C each time it is pressed to a maximum of 30°C. In heating mode, this button raises the set temperature by 1°C each time it is pressed to a maximum of 25°C. 4. (TEMP-) In cooling mode, this button lowers the set temperature by 1°C each time it is pressed, to a minimum of 17°C. In heating function, this button lowers the set temperature by 1°C each time it is pressed to a minimum of 15°C.
is reached. The fan operates at the selected speed. 7. TIMER ON/OFF button for the programmable timer. The timer can be used to turn the unit on automatically after a set time delay is complete. 1. With the unit OFF, press the "TIMER" button to set the desired time delay before you wish the unit to start. 2. Choose the function desired (cooling, dehumidifier, heating or humidifier.) 3. Once the set time delay is complete, the unit will turn on automatically. 4.
set the number of hours required by using the TIMER function. The hours set will be shown on the display by pressing either the TEMP+ or TEMP- buttons.
INSTALLATION Unit Setup 1. Remove the water tank and take out the exhaust hose. 2. Remove the outlet grille and install the exhaust tube by rotating it clockwise onto the rear air outlet. Please ensure it is fully inserted before use. To remove the exhaust hose, please rotate in an anti-clockwise direction. Locating the unit. Install the portable air conditioner in a flat location with adequate space to ensure the air inlets and outlets will not be blocked.
ADJUSTABLE WINDOW SLIDER KIT The adjustable window slider kit is installed as shown below. HEATING / COOLING / DEHUMIDIFYING When using the heating function, remove the exhaust hose (Fig. 2) and replace the opening (Fig. 3) with the outlet grille as shown in Fig. 4. On the opposite end, install the exhaust hose attachment (Fig. 2) onto the unit’s grille as shown in Fig.3. Attach the exhaust hose (Fig.4) onto the exhaust hose attachment (Fig. 2) by rotating it in a clockwise direction.
Once complete, ensure the outlet exhaust is attached to the window when using the heating function. Reverse the process for cooling or dehumidification. HUMIDIFYING When using the humidifying function, remove the exhaust hose and fix the outlet grille on the unit. 1. Fill the water filler and select humidifier function. 2. The unit will stop automatically after four hours of operation. Put water into the water filler to restart operation. 3.
6. Draining tube should be placed lower than the draining hole to allow the water to flow out effectively. MAINTENANCE WARNING: ALWAYS UNPLUG THE UNIT BEFORE MOVING OR CLEANING. CLEANING Air filters The air filters are located on the left and right side of the unit. To remove the air filters, please follows the arrow directions below by pulling out the filters in an upward direction. Clean only with warm soapy water. Cabinet As with filters, clean only with warm soapy water.
CARE OF THE UNIT 1. Only plug the unit into a suitable 220-240V~ 50Hz AC 10 AMP power supply. 2. Hold the plug when unplugging the unit, never pull on the cord. 3. Do not place the unit in direct sunlight. This can fade the plastic case. 4. Do not operate the unit in a confined space. 5. Do not place objects on top of the unit. This blocks the air outlet. 6. Do not place the unit where the air inlets or outlets may be blocked by curtains or furniture. 7. Keep the filters clean.
TROUBLE SHOOTING Never try to repair or dismantle the air conditioner yourself. Unauthorized repairs may result in the loss of warranty and can endanger the user and their property. Problem The air conditioner does not operate. The air conditioner does not seem to operate efficiently. The air conditioner is noisy. The compressor does not work. The remote control does not function. Cause Solution No power supply. Connect to a functioning power supply socket and switch on.
WARRANTY The warranty period is 24 months from the date of purchase. Glen Dimplex Australia Pty Ltd. Glen Dimplex New Zealand Ltd. Unit 1, 21 Lionel Road. 38 Harris Road, East Tamaki, Mount Waverley VIC 3149. Manukau, Auckland 2013 Australia New Zealand Ph: 1300 556 816 Ph: (09) 274 8265 Fax: 1800 058 900 Fax: (09) 274 8472 Web: www.dimplex.com.au Web: www.dimplex.co.nz DISPOSAL • Do not dispose of electrical appliances as unsorted municipal waste. Use separate collection facilities.
SPECIFICATION Model No. DC10RCDH DC12RCDH Power Source 220-240V~50Hz 220-240V~50Hz Power Consumption (EN14511) 1153W/967W 1346W/1129W Rated Power (EN60335) 1280W/1100W 1480W/1300W 3000W/3000W 3500W/3500W 0.2L/H 0.2L/H 360M³/H 450M³/H 50 L/day 60 L/day 2.4L 2.4L Refrigerant R410A R410A Min. room size 10m³ 10m³ Max. room size 22m³ 25m³ Dimensions (mm) 330Wx477Dx630H 330Wx477Dx630H Net Weight 28KG 29.
