INSTRUCTION MANUAL Air Circulator Pedestal Fan Model: DCACP30DC For domestic household use only.
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your air circulator for the first time and keep them in a safe place. WARNING – This appliance must not be used in a bathroom.
• DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings. • DO NOT route cord under furniture or appliances. Take care to position the cord away from traffic areas and where it will not be a tripping hazard. • DO NOT use the unit near windows or where water collects. Rain and water collection may lead to a risk of fire or electric shock. • DO NOT COVER. • Only operate this appliance with a minimum of 50cm clearance all around i.e.
Exposed to the weather outdoors 4 Near water If the power cable wires are frayed or cut Where small children may be left unattended If an extension lead may become overloaded Where the power cable may be damaged On a slope or uneven surface Where there is risk of fire or close to a naked flame Where it may be damaged by chemicals Where there is a risk of interference by foreign objects This product is not made for DIY repair If there is a risk of water falling on the unit
Specification Model no. DCACP30DC Power supply 220-240V~, 50Hz Rated power 35W Speed settings 30 Modes 3 Timer 12 hours Air movement Air speed 25m³/min 7.5m/s Up / Down oscillation 80 degrees Left / Right oscillation 80 degrees Noise level (MAX) Weight (net) Dimensions (w x d x h) 55dB(A) 3.4kg 320 x 360 x 718-854mm • For greater precision, please always refer to the rating label placed on the product.
How It Works In contrast to a traditional fan which brings only cooling benefits when directly facing you; an air circulator works for any season, keeping the air in motion and making the entire room more comfortable to be in. Most fans simply lack the aerodynamics to keep the air in the room in motion. As opposed to blowing air directly in contact with it, our Dimplex air circulators create a 3D oscillating draught in the form of an invisible jet stream.
Parts Front grille Brand badge Base Remote receiver Dial Rear grille Remote Control Extension button Remote Control Storage 7
Control Panel & LED Display Fan Speed LED Display Set Timer Timer Natural Mode Up/Down Oscillation Sleep Mode Left/Right Oscillation On/Off Dial Remote Control On/Off button Timer increase/ decrease button Left/Right oscillation button 8 Mode button Fan speed increase / decrease button Up/Down oscillation button
Operation ON/OFF When in standby mode, press the On/Off button on either the control panel or remote control to turn the unit ON. The On/Off & fan speed indicator lights will illuminate, and the LED Display will show the current fan speed. To turn the unit OFF, press the On/Off button again. FAN SPEED - DIAL When the unit is ON, rotate the dial clockwise to increase the FAN SPEED. The fan speed setting will indicate on the LED display - a number between 1-30. 30 is the highest speed.
Operation TIMER - CONTROL PANEL: The TIMER can be set to automatically turn the unit ON or OFF - up to a maximum of 12 hours. To automatically power ON: 1. Press the TIMER button on the control panel and the TIMER set indicator light will illuminate. The LED Display will flash and start at 1 hour. 2. Turn the dial until the desired time from 1 to 12 hours displays on the LED. After 5 seconds the LED Display will show the time set for the fan to turn ON automatically. 3.
Operation LEFT / RIGHT OSCILLATION • When the unit is ON press the LEFT/RIGHT button on either the control panel or remote control to begin oscillation. The LED indicator will illuminate accordingly and the unit will begin to move left to right within 80°. NOTE: When the fan is first plugged in, it will oscillate 30° to calibrate the setting. (left at 30° with a 9 second pause, followed by turning right to 80° and pausing for 15 seconds).
Cleaning Over time, dust can accumulate on the grille covers and fan blades, which can affect the fans performance. It is recommended to clean the fan at least once a month. 1. Turn the unit OFF and disconnect the appliance from the power supply. 2. Remove any dust build up with a soft brush. 3. To clean the fan blades, remove the screw positioned at the front of the grille and turn the front grille counterclockwise.
Maintenance If the unit fails to operate efficiently, is broken or other problems arise, unplug and do not operate. Ask for advice by calling your local after sales service agent or the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ). Warranty Please refer to the warranty card in the box for warranty information. For any troubleshooting advice, please contact the relative Customer Care Centre below.
Customer Care: 1300 556 816 customer.care@glendimplex.com.au www.dimplex.com.au Supplied by Glen Dimplex Australia 1340 Ferntree Gully Road, Scoresby, Victoria, 3179 © Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Australia.
