INSTRUCTION MANUAL 50cm Box Fan Model: DCBOX50MB For domestic household use only.
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your fan for the first time and keep them in a safe place. WARNING – This appliance must not be used in a bathroom.
• To avoid a fire or electrocution hazard, NEVER put the cord near heat registers, radiator, stoves or heaters. • DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings. • DO NOT route cord under furniture or appliances. Take care to position the cord away from traffic areas and where it will not be a tripping hazard. • DO NOT use the unit near windows or where water collects. Rain and water collection may lead to a risk of fire or electric shock.
Exposed to the weather outdoors 4 Near water If the power cable wires are frayed or cut Where small children may be left unattended If an extension lead may become overloaded Where the power cable may be damaged On a slope or uneven surface Where there is risk of fire or close to a naked flame Where it may be damaged by chemicals Where there is a risk of interference by foreign objects This product is not made for DIY repair If there is a risk of water falling on the unit
Specification Model no. Colour DCBOX50MB Matte Black Power supply 220-240V~ 50-60Hz Rated power 60W Speed settings 3 Modes - Timer - Air volume 50m³/min Adjustable height N/A Tilt adjustable head N/A Oscillation N/A Noise level (MAX) Weight (net) Dimensions (w x d x h) 70dB(A) 3.14kg 500 x 110 x 560mm • For greater precision, please always refer to the rating label placed on the product.
Parts Carry handle Controls Front grille Feet Fan blade Speed control switch 6
Assembly 1. The fan body is ready assembled, however the feet need to be attached to the fan base. 2. Attach the 2 x feet to the base of the fan by aligning the holes, and securing with the (4) screws provided. Stand the fan upright to begin using. IMPORTANT: Ensure the feet are properly secured before placing upright on a firm stable surface. Operation 1. Connect the plug to a power outlet and switch on. 2. Once the feet are assembled, stand the unit upright on a firm stable surface. 3.
Cleaning Over time, dust can accumulate on the rear grille cover and fan blades, which can affect the fans performance. It is recommended to clean the fan at least once a month. 1. Turn the unit OFF and disconnect the appliance from the power supply. 2. Remove any dust build up with a soft brush. 3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used for any stubborn marks. Note: The fan grill cannot be removed, and doing so may void your warranty.
Maintenance If the unit fails to operate efficiently, is broken or other problems arise, unplug and do not operate. Ask for advice by calling your local after sales service agent or the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ). Warranty Please refer to the warranty card in the box for warranty information. For any troubleshooting advice, please contact the relative Customer Care Centre below.
Customer Care: 1300 556 816 customer.care@glendimplex.com.au www.dimplex.com.au Supplied by Glen Dimplex Australia 1340 Ferntree Gully Road, Scoresby, Victoria, 3179 © Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Australia.
