INSTRUCTION MANUAL 10L Evaporative Cooler Model: DCEVP10 For domestic household use only.
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/ OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your evaporative cooler for the first time and keep them in a safe place. WARNING – This appliance must not be used in a bathroom.
• Never use the mains lead as a carrying strap or pulling lead. • To avoid a fire or electrocution hazard, NEVER put the cord near heat registers, radiator, stoves or heaters. • DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings. • DO NOT route cord under furniture or appliances. Take care to position the cord away from traffic areas and where it will not be a tripping hazard. • DO NOT use the unit near windows or where water collects.
Exposed to the weather outdoors 4 Near water If the power cable wires are frayed or cut Where small children may be left unattended If an extension lead may become overloaded Where the power cable may be damaged On a slope or uneven surface Where there is risk of fire or close to a naked flame Where it may be damaged by chemicals Where there is a risk of interference by foreign objects This product is not made for DIY repair If there is a risk of water falling on the unit
Specification Model no. Colour DCEVP10 White/Black Power supply 220-240V~, 50Hz Rated power 68W Speed settings Modes Turbo air speed Water tank capacity Remote control Timer Swing function Controls Max. room size Water consumption Weight (net) Dimensions (w x d x h) 4 3 (natural, normal & sleep) 8m/s 10L Y 0-15 hours Y - Auto Button with LED display 20m² 1.1L/h (high speed) 9.92kg 380 x 310 x 760mm • For greater precision, please always refer to the rating label placed on the product.
Parts Display panel Control panel Horizontal louvers Filter Water tank fill opening Water Tank Castors OSC. MODE TIMER PRESET HUM.
Display & Control Panel Normal Remote Control Fan Speed Increase Left/right swing On/Off OSC. TIMER PRESET Timer Fan Speed Decrease Mode MODE HUM.
Functions Note: The buzzer will make a long sound when the power supply is first connected and the indicators will flash for 2s. The unit is in ‘standby’ until the ON/ OFF button is pressed. ON/OFF After connecting the cord to a power outlet press the ON/OFF button to turn the unit ON. To turn the unit OFF press this button again. FAN SPEED The unit has 4 FAN SPEEDS and is adjusted from the lowest speed to the highest speed.
Functions HUMIDIFY To activate the HUMIDIFY function, press the HUMIDIFY button once to turn on. Ensure there is enough water in the water tank. The LED indicator light will illuminate once activated. Press this button again to turn off the HUMIDIFY function, and to use as a fan only. The unit is also equipped with the below functions. LOW WATER PROTECTION When there is insufficient water in the water tank, the pump will stop working for 1 minute, and then the LOW WATER indicator will start to flash.
Set Up IMPORTANT: Never remove the water tank or open the cover when the unit is ON and operating! ICE PACKS The unit comes with 2 x ice packs. Ice packs are used to increase the cooling capacity. Please place the ice packs in the freezer before use. It takes about 4 hours to freeze completely - depending on the freezer. 1. Once the ice pack is frozen, place the ice pack in the position by the rear filter screen - refer to below diagram. 2.
Operation 1. Remove the unit from its packaging 2. To begin using the HUMIDFY function, ensure the water tank is filled with water by checking the water level window indicator. 3. For extra cooling power, place the ice pack (supplied) into the unit as described on page 10.. 4. Plug into a power supply and press the ON/OFF button to start the appliance. 5. The unit will operate initially on a continual basis. If a set period of operation is required, please follow the TIMER instructions on page 8. 6.
Cleaning Your unit is designed to remove dirt and other atmospheric impurities by drawing air through the air filter. DO NOT block the air filter, as this will impair the efficiency of the unit. Pushing the unit up against a wall or operating it in close proximity to long window drapes will also impair the unit’s air flow and efficiency. Rear Air Filter • This is easily accessible by removing the rear screen and filter. • Disconnect the unit from the main supply & remove the filter.
Maintenance Storage If not using the unit for an extended period of time. After cleaning please: • Turn the unit off, unplug and take care of the mains lead & plug. • Cover the unit and store it upright in a location where it will not receive direct sunlight. NB- Prolonged exposure to direct sunlight will discolour the enclosure. If you have lost your user manual of the unit fails to operate efficiently, is broken or other problems arise, unplug and do not operate.
Customer Care: 1300 556 816 customer.care@glendimplex.com.au www.dimplex.com.au Supplied by Glen Dimplex Australia 1340 Ferntree Gully Road, Scoresby, Victoria, 3179 © Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Australia.
