Service manual

3
Remote Control
The replace is supplied with a radio frequency remote
control. This remote control has a range of approximately
50 feet (15.25 m), it does not have to be pointed at the
replace and can pass through most obstacles (including
walls). It is supplied with one of hundreds of independent
frequencies to prevent interference with other units.
!
NOTE: Before attempting any operation with the
remote, pull the plastic insulator strip out from between
the remote casing and battery cover (Figure 2).
Remote Operation
The replace is supplied with an integrated on/off remote
control.
!
NOTE: Ensure that the replace 3-Position Switch is set
to the remote control setting.
To operate, push the ON button to turn replace on, push
the OFF button to turn the replace off.
Remote Control Initialization/Reprogramming
If the remote control or remote control receiver has been
replaced, follow these steps to initialize the remote control
and receiver:
Set the main power switch to OFF.1.
Wait a minimum of ve (5) seconds and set the 3 2.
Position Switch to the position (Figure 1A).
Within 3. 10 seconds of re-acquiring power, press the ON
button located on the remote control.
!
NOTE: You will have only 10 seconds to perform this
last step. Failure to do so will result in these steps needing
to be followed again.
This will synchronize the remote control and receiver.
Battery Replacement
To replace the battery:
Slide battery cover open on the remote contol 1.
(Figure 2).
Install one (1) 12-Volt (A23) battery in the battery 2.
holder.
Close the battery cover3.
Battery must be recycled or disposed of properly.
Check with your Local Authority or Retailer for
recycling advice in your area.
OPERATION
The controls are located inside the door panel on the lower
side of the Corner Standing Stove (Figure 1).
A. 3-Position Switch
The switch has two ON positions marked with “
” and “
Manual ”. The “ Manual ” position is for manual operation.
In this position the built-in remote control is bypassed.
The “
” position is for operating the unit with the provided
remote control. When in “
” position the unit is operated
with the ON and OFF buttons of the remote control.
When the switch is in the center “ O ”position the unit is off.
B. Heater On/Off Switch
The Heater On/Off Switch supplies power to the heater
element. When the switch is in the ON position the heater
operates if the thermostat calls for heat.
C. Heater Thermostat Control
To adjust the temperature to your individual requirements,
turn the thermostat control clockwise all the way to
turn on the heater. When the room reaches the desired
temperature, turn the thermostat knob counter clockwise
until you hear a click. Leave in this position to maintain the
room temperature at this setting. For additional heat, turn
clockwise until you hear the click again and the heater will
turn on.
Resetting The Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn
the replace off and it will not come back on without being
reset. It can be reset by switching the 3-Position Switch to
OFF and waiting ve (5) minutes before switching the unit
back on.
CAUTION: If you need to continuously reset the heater,
disconnect power and call Dimplex customer service at
1-888-DIMPLEX (1-888-346-7539).
Figure 2
Off Button
On
Button
Battery
Cover
Plastic
Strip
Figure 1
Door Panel
EMSC Models
DCF7850 Models
A
B
C