Service manual

4 www.dimplex.com
MAINTENANCE
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of re,
electric shock or damage to persons.
Light Bulb Replacement
Allow at least ve (5) minutes for light bulbs and heater to
cool off before touching bulbs to avoid accidental burning of
skin.
Light bulbs need to be replaced when you notice a dark
section of the ame or when the clarity and detail of the log
exterior disappears. There are two (2) bulbs under the log
set which generate the ames and embers.
Tool requirements: Phillips screwdriver.
Helpful Hints
It is a good idea to replace all light bulbs at one time if they
are close to the end of their rated life. Group replacement
will reduce the number of times you need to open the unit
to replace light bulbs.
Light Bulb Requirements
Quantity of two (2) clear chandelier or candelabra bulbs
with an E-12 (small) socket base, 60 Watt rating.
Replacement:
1. Unplug the unit from the outlet.
2. Remove the rear door from the left side of the unit by
unfastening one (1) Phillips screw (Figure 3). Set the
door and screw aside.
3. Reach inside opening to remove the bulb(s). Remove
the nearest bulb before attempting to remove the
further bulb. Bulbs are unscrewed in counter-clockwise
direction.
4. Insert new bulb(s).
5. Replace rear door and fasten in place.
6. Plug in the Corner Standing Stove.
Glass Cleaning
The front glass is cleaned in the factory during the
assembly operation. During shipment, installation,
handling, etc., the front glass may collect dust particles,
these can be removed by dusting lightly with a clean dry
cloth.
To remove ngerprints or other marks, the glass can be
cleaned with a damp cloth. The glass should be com-
pletely dried with a lint free cloth to prevent water spots. To
prevent scratching, do not use abrasive cleaners or spray
liquids on the glass surface.
Surface Cleaning
To remove ngerprints or other marks, the exterior nish
can be cleaned with a damp cloth with a mild detergent.
The surface should be completely dried with a lint free cloth
to prevent water spots.
To prevent scratching, do not use abrasive cleaners or
spray liquids on any surface.
Figure 3
Screw
Rear Door
Bottom of unit