For service questions, please call Dimplex at 1-888-346-7539. For sales inquiries, please call Sylvane at 1-800-934-9194 or visit sylvane.com. Owner’s Manual Model Numbers: EMC4240 DCH4831L Quality checked by: Serial Number Model Number Part Number Thank you and congratulations for purchasing a Dimplex electric heater, the world leader in electric heat.
QUICK REFERENCE GUIDE 1. Prior to the first use of the heater verify that the circuit breakers for the heater on. 2. The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by the initial heating of internal heater parts and will not occur again. 3. If you have any technical questions, questions regarding the operation of your heater, or require service for your heater contact Dimplex North America customer service at 1-888-DIMPLEX (1-888-346-7539).
IMPORTANT INSTRUCTIONS Please Retain This Owner’s Manual For Future Reference When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before using this heater. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use the attached handle when moving this heater.
13. 14. 15. 16. 17. 18. 19. may become blocked. All electrical heaters have hot, and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or flammable liquids are stored or where the unit will be exposed to flammable vapors. Do not modify this heater. Use it only as described in this manual. Any other use is not recommended by the manufacturer and may cause fire, electric shock or injury to persons. Avoid the use of an extension cord.
Grounding Instructions This heater is for use on 240 Volts. The cord has a plug as shown on Figure 1. No adapter should be used with this unit. The type outlet is a 240 Volt grounding outlet. When properly installed, it provides a ground connection through the cord to the heater to protect the operation from electric shock. Heater Location And Clearances The heater is intended for use located on a hard floor, table top, desk or on shelf, and the like.
Figure 3 Down Position Operation (Setting the Thermostat) 1. Before connecting or disconnecting plug, turn knob fully counterclockwise (see Figure 4). 2. Heater is equipped with a thermostat. To adjust temperature to your individual requirements, turn thermostat control knob clockwise all the way to turn heater on, the yellow power light will illuminate (Figure 5). When room reaches desired temperature, turn thermostat knob counterclockwise until you hear a click.
For service questions, please call Dimplex at 1-888-346-7539. For sales inquiries, please call Sylvane at 1-800-934-9194 or visit sylvane.com. Maintenance and Cleaning Warning: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. Allow at least 30 minutes for the heater to cool before attempting any maintenance or cleaning. To clean the exterior surface, use a solution of water and mild detergent, apply with damp sponge.