DCPF40C 40cm High Velocity Pedestal Fan INSTRUCTION MANUAL PLEASE READ THE INSTRUCTION MANUAL CAREFULLY BEFORE USING THE UNIT. www.dimplex.com.
CONTENTS WARNINGS AND PRECAUTIONS 1 STRUCTURE 3 OPERATION 4 CLEANING AND MAINTENANCE 6 TECHNICAL REFERENCE DATA 8 WARRANTY 8 www.dimplex.com.
WARNINGS & PRECAUTIONS Warnings • Never place the unit near gas appliances, flames or • Flammable liquids. • Never hit or shake the unit. Doing so may cause damage. • Never cover or obstruct the air inlet or outlet. • Doing so may cause overheating. • Never spray water on or place the unit near water. • Doing so may cause electric shock. • Never connect other appliances to the same power outlet. • Never connect or disconnect the power plug with wet hands. • Doing so may cause electric shock.
WARNINGS & PRECAUTIONS • • • • • • • • • • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure they do not play with the appliance. Avoid electromagnetic interference.
STRUCTURE 1. 2. 3. 4. 5. 6. 7. 8. 9. Front grille Blade locking cap Blade Guard knob Rear grille Motor shaft Rotary switch Oscillation knob Motor housing 10. Power cord & plug 11. Fixing screw A 12. Upper pillar 13. Fixing screw B 14. Main pillar 15. Base 16. Pole fixing nut 17.
OPERATION BEFORE FIRST USE • Please read these instructions carefully before use and keep them for future reference. • Check your local main voltage whether it is the same as stated on the appliance. • Before using for the first time, remove any protective films or stickers from the appliance and ensure the power switch is in the “0” position. ASSEMBLY 1. Remove the pole fixing nut (16) from the main pillar (14) and insert the main pillar (14) into the base (15) then tighten the fixing nut (16). 2.
OPERATION Connect the plug to a power supply and switch on the power. On/Off • Switch the fan on by rotating the speed control knob (7) at the rear in clockwise direction. The switch is also used to adjust the fan speed from LOW ”1” – MEDIUM ”2” - HIGH ”3” in sequence. • The airflow direction can be adjusted upward/downward by lifting up or pressing down the motor housing. NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your fingers through the guard.
CLEANING & MAINTENANCE CLEANING Over time, dust can accumulate on the rear grille cover and fan blades, which can affect the fans performance. It is recommended to clean the fan at least once a month. 1. Turn the unit OFF and disconnect the appliance from the main power supply. 2. Remove any dust build up with a soft brush. 3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used for any stubborn marks. 4.
TECHNICAL & REFERENCE DATA • If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the ground water, polluting the food chain and damaging health and well-being. MAINTENANCE If the unit fails to operate efficiently, is broken or other problems arise, unplug and do not operate. Ask for advice by calling your local after sales service agent or the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ). MODEL NO.