Owner’s Manual Model DFP15-1131HO DFP15-1132NG IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this fireplace. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage.
Table of Contents Welcome & Congratulations. . . . . . . . . . 3 Important Instructions. . . . . . . . . 4 Quick Reference Guide. . . . . . . . . . . . . . 7 Fireplace Installation . . . . . . . . . . . . . . . 7 Operation . . . . . . . . . . . . . . . . . . . . . . . . . 8 Maintenance. . . . . . . . . . . . . . . . . . . . . . . 9 Warranty. . . . . . . . . . . . . . . . . . . . . . . . .
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Electralog, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
Important Instructions When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: ① Read all instructions before using this appliance. ② The heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation.
Important Instructions plug from the outlet. ⑩ Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage to the heater. ⑪ To prevent a possible fire, do not block air intake or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. ⑫ All electrical heaters have will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug.
Important Instructions ! NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void user's authority to operate the equipment. ! NOTE: A 15amp, 120 volt alternating current (VAC) circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or fuse blows on a regular basis when the heater is operating.
Quick Reference Guide ① The information regarding the model of your electric fireplace can be found on the label located on the back of the unit. ② If you have any technical the operation of your electric fireplace, or require service contact customer service. ③ For dimensions of your fireplace, refer to Figure 1. questions or concerns regarding Figure 1 749.3mm [29.5"] 260.3mm [10.5"] 698.5mm [27.
Operation Figure 2 C B A A - Two Position On/Off Switch (Figure 2) The power switch controls the electricity supply to the heater, flame effect and pilot light. When the switch is in the “ I ” position the unit is ON and when the switch is in the " O " position the unit is OFF. ! Note: When the pilot light is lit but flames are not present, power is still supplied to unit and flame effect light bulb should be replaced. heater operates on HIGH.
Maintenance WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. Figure 3 WARNING: Any other maintenance should be performed by an authorized service representative. Bulb Replacement Allow at least five (5) minutes for light bulbs and heater to cool off before touching bulbs to avoid accidental burning of skin. The bulb is located behind the back panel.
Warranty Products to which this limited warranty applies: This limited warranty applies to the following models of your newly purchased Electralog electric fireplace DFP15-1131MA and DFP15-1132NG. This limited warranty applies only to purchases made in any province of Canada except for Yukon Territory, Nunavut, or Northwest Territories or in any of the 50 States of the USA (and the District of Columbia) except for Hawaii and Alaska.
Warranty This limited warranty does not apply to products that have been repaired (except by Electralog or its authorized service representatives) or otherwise altered. This limited warranty does further not apply to defects resulting from misuse, abuse, accident, neglect, incorrect installation, improper maintenance or handling, or operation with an incorrect power source.
Warranty the product or part (or any replacement product or part) or any labour or transportation costs. Such costs shall be the purchaser’s responsibility.
Replacement Parts Flicker Motor. . . . . . . . . . . . . . . . . . . . 2000220100RP Flicker Rod . . . . . . . . . . . . . . . . . . . . . 5902110100RP Heater Assembly . . . . . . . . . . . . . . . . 2203530200RP On/Off Switch . . . . . . . . . . . . . . . . . . . 2800070700RP Heater On/Off Switch. . . . . . . . . . . . . 2800070900RP High Heat On/Off Switch. . . . . . . . . . . 2800071000RP Cord Set . . . . . . . . . . . . . . . . . . . . . . . 4100010700RP Log Set . . . . . . . . . . . . . .
