Service manual

RESETTING THE TEMPERATURE CUTOFF SWITCH
This unit is equipped with a thermostat that controls the temperature of the room.
It does this by turning the heater on and off. The heater is protected with a safety
device to prevent overheating. Should the heater overheat, an automatic cut out
will turn the heater off and it will not come back on without being reset. To reset
the temperature cut-off switch turn the main power switch to the OFF position
and wait five minutes before switching the unit back on.
CAUTION
If you need to continuously reset the heater, unplug the unit and call Dimplex
North America Limited at 1-800-668-6663.
REMOTE CONTROL USAGE
This fireplace is supplied with a radio frequency remote control. This remote
control has a range of approximately 50 feet (15.25m); it does not have to be
pointed at the fireplace and can pass through most obstacles (including walls). It is
supplied with one of 243 independent frequencies to prevent interference with
other units. The frequency code is indicated on the back of the transmitter.
Note: Ensure that the fireplace 3 position
switch is set to the remote control setting.
To operate, push the ON button to turn fireplace
on, push the OFF button to turn the fireplace off.
BATTERY REPLACEMENT
To replace the battery, slide battery cover open
on the hand held transmitter. Correctly install
one 12 volt (A23) battery in the battery holder.
Close the batter cover.
Remote Control Initialization
This procedure is required every time there is a
loss of power to the remote control in the
fireplace. (I.e. power failure, breaker tripped,
main power switch is turned off)
1. Ensure that power is supplied through main
service panel.
2. Locate manual controls.
3. Toggle the main power switch, to the“
”
position.
4. Press ON button located on the remote control
transmitter. This will synchronize the remote
control transmitter and receiver.
4