For service questions, please call Dimplex at 1-888-346-7539. For sales inquiries, please call Sylvane at 1-800-934-9194 or visit sylvane.com. Owner’s Manual Model DGWH4031 IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this heater. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.
Table of Contents Welcome & Congratulations . . . . . . . . . . . . . . . . 3 Important Instructions. . . . . . . . . . . . . . . 4 Heater Installation . . . . . . . . . . . . . . . . . . . . . . . . 7 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Maintenance and Cleaning. . . . . . . . . . . . . . . . 10 Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Replacement Parts . . . . . . . . . . . . . . . . . . . . . . .
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric heater from Dimplex, the world leader in electric heaters. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
Important Instructions When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to person, including the following: ① Read all instructions before using this appliance. ② The heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation.
Important Instructions objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage to the heater. ⑫ To prevent a possible fire, do not block air intake or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. ⑬ All electrical heaters have hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or flammable liquids are used or stored, or where the unit will be exposed to flammable vapors.
Important Instructions Grounding Instructions This heater is for use on 240 Volts. The cord has a plug as shown on Figure 1. No adapter should be used with this unit. The type outlet is a 240 Volt grounding outlet. When properly installed, it provides a ground connection through the cord to the heater to protect the operation from electric shock. 6 Figure 1: Plug and outlet configuration for 240 Volt, 20 Amp circuit Plug Outlet Ground www.dimplex.
Heater Installation HEATER LOCATION AND CLEARANCES The heater is intended for flat use on a hard floor, table top, desk or on shelf, and the like, or suspended on a wall or ceiling by means of provided hanger bracket. When suspended from wall or ceiling, heater should be located along outside walls to provide perimeter air circulation. The discharge air should wipe the walls without blowing directly on them.
Heater Installation handle. Figure 3 3. Slide spacer over the carriage bolt shaft and insert in hanger bracket opening and hold them in position. 4. Slide lock washer and thread on T-Handle onto carriage bolt, turning to tighten. Hanger Bracket T-Handle Lock Washer Spacer Carriage Bolt Air In Air Out Hanger Bracket Mounting Options 8 www.dimplex.
Operation Setting the Thermostat 1. Before connecting or disconnecting plug, turn knob fully counterclockwise. (Figure 4) 2. Heater is equipped with a thermostat. To adjust temperature to your individual requirements, turn thermostat control knob clockwise all the way to turn heater on. The yellow power light will illuminate (Figure 5). When room reaches desired temperature, turn thermostat knob counterclockwise until you hear click. Leave in this position to maintain room temperature at this setting.
Maintenance and Cleaning Warning: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. CAUTION: Allow at least 30 minutes for the heater to cool before attempting any maintenance or cleaning. To clean the exterior surface, use a solution of water and mild detergent, apply with damp sponge. Wipe dry with a dry cloth. DO NOT plug heater into outlet until it has dried thoroughly.
For service questions, please call Dimplex at 1-888-346-7539. For sales inquiries, please call Sylvane at 1-800-934-9194 or visit sylvane.com. Replacement Parts Fan Blade . . . . . . . . . 1900010022RP Motor Kit . . . . . . . . . . 2000020022RP Fan Delay . . . . . . . . . . . 00033002RP Thermostat . . . . . . . . . . 13678001RP Cutout . . . . . . . . . . . . . . . 0009112RP Knob - Clear . . . . . . . . . 02210011RP Hanger Bracket. . . . .
