Installation Guide

ManualsBrandsDimplex ManualsHeating, Ventilation, and Air ConditioningTraditional 400 sq. ft. Electric Stove in Pewter

Service Manual

Model Number

DS5629

UL Part Number

6900471359

7400490000R02

In keeping with our policy of continuous product development, we reserve the right to make changes without notice.

Dimplex North America Limited

1367 Industrial Road

Cambridge ON Canada N1R 7G8

1-888-346-7539 www.dimplex.com

REV PCN DATE

01 - 9-Sep-11

02 13147 16-Apr-12

IMPORTANT SAFETY INFORMATION: Always read this manual rst before attempting to service

this stove. For your safety, always comply with all warnings and safety instructions contained in this

manual to prevent personal injury or property damage.

Summary of content (12 pages)

PAGE 1
Service Manual Model Number DS5629 UL Part Number 6900471359 IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to service this stove. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. Dimplex North America Limited 1367 Industrial Road Cambridge ON Canada N1R 7G8 1-888-346-7539 www.dimplex.
PAGE 2
TABLE OF CONTENTS OPERATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Exploded Parts Diagram. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
OPERATION Figure 1 Remote Control The stove is supplied with a radio frequency remote control. This remote control has a range of approximately 50 feet (15.25 m), it does not have to be pointed at the stove and can pass through most obstacles (including walls). It is supplied with one of hundreds of independent frequencies to prevent interference with other units.
PAGE 4
Maintenance WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. Light Bulb Replacement Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental burning of skin. Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. There are two bulbs under the log set which generate the flames and embers.
PAGE 5
Exploded Parts Diagram 10 15 5 20 17 6 11 4 16 7 9 8 13 2 1 20 18 12 19 3 14 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Cutout . . . . . . . . . . . . . . . . . . . . . . . . . . 2300270100RP Flicker Motor . . . . . . . . . . . . . . . . . . . . . 2000210200RP Heater/Blower Assembly . . . . . . . . . . . . 2200490700RP Thermostat . . . . . . . . . . . . . . . . . . . . . . 2300150100RP* 3 Position Switch . . . . . . . . . . . . . . . . . . 2800071100RP Heater On/Off Switch . . . . . . . . .
PAGE 6
Wiring Diagram 6 www.dimplex.
PAGE 7
LIGHT BULB REPLACEMENT CAUTION: If unit was operating prior to servicing allow at least 5 minutes for lights to cool off to avoid accidental burning of skin. Figure 4 WARNING: Disconnect power before attempting any maintenance to reduce the risk of electric shock or damage to persons. Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. There are three bulbs under the log set which generate the flames and embers.
PAGE 8
front of the emberbed and remove the grate from the unit. 3. Remove the logset from the unit by pulling forward and lifting out. 4. Remove the reflector rod from the flame motor by pulling the end of the rod to the left and carefully remove flame rod from rubber sleeve. 5. Reassemble in the reverse order as above.
PAGE 9
Figure 8 to persons. 1. Open door by pulling the handles. 2. Loosen the 2 retainers on the inner sides of the unit by turning counter clockwise. 3. Remove 4 screws that secure the top on the rear of the unit. 4. Lift the top off of the unit. Carefully remove the partially reflective glass and store in a safe place to prevent damage. WARNING: Disconnect power before attempting any maintenance to reduce the risk of electric shock or damage to persons. 1. Gently place stove on it’s back on a flat surface. 2.
PAGE 10
HEATER ASSEMBLY REPLACEMENT WARNING: If the stove was operating prior to servicing, allow at least 10 minutes for light bulbs and heating elements to cool off to avoid accidental burning of skin. WARNING: Disconnect power before attempting any maintenance to reduce the risk of electric shock or damage to persons. 1. Gently place stove on it’s back on a flat surface. 2. Remove the heater cover retaining screws located on the bottom of the stove and lower heater/light assembly onto the floor. 3.
PAGE 11
Troubleshooting Guide Problem Cause Solution General Circuit breaker trips or fuse blows when unit is turned on Short in unit wiring. Trace wiring in unit. Improper circuit current rating Additional appliances may exceed the current rating of the circuit breaker or fuse. Plug unit into another outlet or install unit on a dedicated 15 amp circuit. Unit turns on or off by itself Remote control has a similar frequency to other remotes in the area.
PAGE 12
Problem Cause Solution Heater Heater is not turning off Heater is not turning on Improper operation Refer to Operation Section Defective heater on/off switch Replace heater on/off switch Defective Thermostat Replace Thermostat Defective Remote Control Receiver Replace Remote Control Receiver, initialize with remote control Improper operation Refer to Operation Section Loose wiring Check wiring connections Defective heater on/off switch Replace heater on/off switch Defective Thermostat Re