Owner’s Manual Models: DVF1200, DVF1500 & DVF1800 CONSUMER SAFETY INFORMATION: PLEASE READ THIS MANUAL BEFORE INSTALLING AND OPERATING THIS APPLIANCE. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN A POSSIBLE ELECTRIC SHOCK, FIRE HAZARD, AND/OR INJURY AND WILL VOID THE WARRANTY. This instruction can be also downloaded from our company website. To view the full line of Dimplex products, visit www.dimplex.com.au or www.dimplex.co.nz V 1.
Table of Contents Welcome .............................................................3 IMPORTANT INSTRUCTIONS............................ 4 ......................................................6 Installation ...........................................................7 Operation...........................................................16 Maintenance ......................................................19 Troubleshooting .................................................21 Warranty ......................
Welcome Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please record your model and serial numbers below for future reference: model and serial numbers can be found on the Model and Serial Number Label of your fireplace. Model Number Serial Number CAUTION: Read all instructions and warnings carefully before starting installation. and will void the warranty.
IMPORTANT INSTRUCTIONS Read this manual before attempting to install or use the electric fireplace. Always comply with the warnings and safety instructions contained in this • WARNING: In order to avoid overheating, do not cover the heater. property damage. • Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
IMPORTANT INSTRUCTIONS • CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
Electrical Voltage: Watts: Amps: Wiring: Bulb Type: Dimensions 220V~240V 50Hz 1 300~1 600 Watts 6-7 A Plug-In LED DVF1200 Width: Height: Height with feet: Depth: Depth with feet: 1046 mm 460 mm 547 mm 133 mm 279 mm Weight 18.5 kg DVF1500 Width: Height: Height with feet: Depth: Depth with feet: 1318 mm 460 mm 547 mm 133 mm 279 mm Weight 28.9 kg DVF1800 Width: Height: Height with feet: Depth: Depth with feet: Weight 35.
Installation GROUNDING INSTRUCTIONS • This product is equipped with a cord that has an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. • This heater is for use on 220-240 volts. Grounding Pin • A 10 Amp, 220-240 Volt circuit is required. A dedicated circuit is preferred, but not essential in all cases.
Package Contents Tools required A B C D x6 x6 x2 x4 E K F G H I L J 8
Installation IN-WALL INSTALLATION Cabinet - mm Model DVF1200 DVF1500 DVF1800 A 1057 1331 1636 B 165 165 165 C 470 470 470 C B A Firebox - mm Model DVF1200 DVF1500 DVF1800 D 1046 1318 1626 E 119 119 119 F 460 460 460 D F E 9
Installation IN-WALL INSTALLATION 1 E 2 1 E 2 B 3 x6 E 10 11
Installation 4 G&H H I J 5 F 6 Lock glass in place Unlocked 12 Move to lock Locked 11
Installation ON-WALL INSTALLATION 1 A 2 Dimensions - mm Model B Wall B DVF1200 DVF1500 DVF1800 A 406 813 813 B 200 200 200 A x6 B x6 3 12 13
Installation 4 G&H H I J 5 F Lock glass in place 6 14 Unlocked Move to lock Locked 13
Installation TABLE TOP INSTALLATION 1 D K x4 2 14 G&H H I J 15
Installation 3 4 F Lock glass in place Unlocked Move to lock Locked C x2 16 15
Operation The fireplace can be operated with the multi–function IR remote control or from the touchscreen controls on the top-right of the front glass. Once the fireplace is turned on the digital display and the control icons on the front glass will illuminate. If no button or icon is pressed within 10 seconds, the fireplace controls will deactivate by the digital display turning off first and then the icons. To reactivate the controls press any button on the remote or touch any icon on the front glass.
Operation POWER ON/OFF The ON/OFF button turns the fireplace ON and OFF. When the fireplace is OFF, pressing the ON/OFF button on the remote control or touching the icon on the front glass will turn on the fireplace. If the ON/OFF button is pressed again within 10 seconds it will turn OFF the fireplace. With inactive controls, press twice to turn OFF the fireplace. The first press on the ON/OFF button lights up the touchscreen icons and activates the controls. The fireplace has a built-in memory function.
Operation Heater Enable & Disable Function: From the touchscreen controls touch and hold the Heat icon for 10 seconds. The ember bed will flash 6 times to indicate that the heater function is disabled. When the heat is disabled, pressing the Heat button will cause the ember bed to flash, but the heater will not operate. To enable the heater again, touch and hold the Heat icon for 10 seconds. ! NOTE: This function cannot be set with the remote control.
Maintenance • Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or household cleaners as these products will damage the metal trim. • The motors used on the fan and the flame generator assembly are prelubricated for extended bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater and air intake/output vents is recommended.
Maintenance Disposal of Used Batteries Batteries may contain hazardous substances that could be endangering to environment and human health. • This symbol marked on the battery and/or packaging indicates that used batteries shall not be treated as municipal waste. Instead they shall be left at the appropriate collection point for recycling. • By ensuring the used batteries are properly disposed of, you will help prevent potential negative consequences for the environment and human health.
Troubleshooting Fault code Fault Cause E1 The heater is overheating Call technical support. E2 Thermistor is defective. Call technical support. E3 The heater not working. If the vents are dirty or clogged. Unplug the power, clean the dust and debris of the vent area. Wait for 5 minutes, plug in and turn on the heater. If the heater still don't work, please call technical support.
Warranty Two Year Limited Warranty Products to which this limited warranty applies This limited warranty applies to your newly purchased Dimplex Versa Fireplaces. This limited warranty applies only to purchases made in any State and Territory of Australia and New Zealand. This limited warranty applies to the original purchaser of the product only and is not transferable.
Warranty product or part) to and from the authorised dealer’s or service agent’s place of business. 4) This limited warranty does not entitle the purchaser to on-site or in-home services. On-site or in-home services may be performed at the purchaser’s request and expense at Glen Dimplex’s then-current rates for such services. GLEN DIMPLEX, OR ITS OFFICERS, DIRECTORS, OR AGENTS BE LIABLE FOR ANY DIRECT LOSSES, COSTS, OR DAMAGES THAT EXCEED THE PURCHASE PRICE OF THE PRODUCT.
Technical Service Contact our friendly customer service team for technical and troubleshooting support. Make sure you have your sales receipt, location of purchase, and the model and serial number of your product. Australia 1300 556 816 www.dimplex.com.au/en-au/support/contact-us 8, Lakeview Drive, Scoresby VIC 3179 New Zealand 09 274 8265 www.dimplex.co.