Service manual

11
7. Remove the end panel being careful not to add any
strain to the wires connecting to the controls.
8. Gently guide the partially reective glass out the open
side of the rebox.
9. Turn the rebox upright and remove the screws that se-
cure the ame panel to the back panel. See Figure 6 to
determine which screws are required for your particular
model of rebox.
10. Move the standoffs from the old panel to the new panel.
11. Re-assemble the remainder of the replace in reverse
order from the instructions above.
CAUTION: Ensure that the remote control wire antenna
is placed so that it is not caught between any of the
screws or sheets of metal.
!
NOTE: Be sure that the anges on the end panel are
positioned on the interior of the outside panel of the re-
place.
POWER CORD REPLACEMENT
Tools Required: Philips head screwdriver
Needle-nose pliers
Flat Head Screwdriver
WARNING: If the replace was operating prior to ser-
vicing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Remove the frame ller strip and carefully remove the
glass or trim assembly from the unit.
2. Carefully remove the media from the front tray.
3. Wall Mount: Remove the replace assembly from the
wall by carefully lifting it upward, releasing it from the
anges of the wall-mounting bracket. (Figure 4).
Pedestal Mount: Carefully lay the unit face down on a
at surface and remove the six (6) screws holding the
pedestal to the unit. (Figure 5)
4. Carefully set the unit upright on a at working surface.
!
NOTE: If necessary, lay a protective barrier between
the unit and your work surface, (i.e. cloth, cardboard, thick
plastic) to avoid scratching your work surface.
5. On the right end, with the controls, remove the seven
(7) screws around the outside of the end panel. (Figure
5)
6. Lay unit on its back and remove the remaining nine (9)
screws from the end panel.
7. Remove the end panel being careful not to add any
strain to the wires connecting to the controls.
8. Follow the wiring from the power cord up to the controls
and remote control receiver board, removing any tie
wraps and remove the connections, taking note of the
original locations.
!
NOTE: Use a at head screwdriver to gently pry
between the end of the connector and the switch to release
the wires.
9. With needle nosed pliers, squeeze and push the grom-
met securing the power cord out of the casing.
10. Insert the new power cord and grommet, reattaching
the wire with new tie wraps.
11. Reconnect the wires according to their original congu-
ration.
12. Re-assemble the remainder of the replace in reverse
order from the instructions above.
Front Panel Screws
Figure 7
Heater Screws
Figure 6
Flame Panel Screws
Flame Panel Screws
DWF1215/DF1135
DF1136