Service manual

ManualsBrandsDimplex ManualsHeating SystemDWF1215

bushing in the center of the icker rod is completely set in

the support bracket. The bushing must be properly aligned

for it to go all the way down into the bracket.

17. Feed the icker motor wires through back up the side

of the rebox, ensuring that any tie wraps that were

removed get replaced.

18. Reconnect the icker motor wires and capacitor into

the appropriate terminals in the terminal block, accord-

ing to their original conguration.

NOTE: It is helpful to use needle nose pliers to feed

the wires and hold them in position with one hand while

you secure the terminal screw into position with the other.

Once the screw is tightened, give a gentle tug on the wires

to ensure they are secure.

19. Re-assemble the remainder of the replace in reverse

order from the instructions above.

CAUTION: Ensure that the remote control wire antenna

is placed so that it is not caught between any of the

screws or sheets of metal.

NOTE: Be sure that the anges on the end panel are

positioned on the interior of the outside panel of the re-

place.

LED LIGHT STRIP REPLACEMENT

Tools Required: Philips head screwdriver

Flat head screwdriver

Needle-nose pliers

WARNING: If the replace was operating prior to ser-

vicing, allow at least 10 minutes for light bulbs and heating

elements to cool off to avoid accidental burning of skin.

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

1. Remove the frame ller strip and carefully remove the

glass or trim assembly from the unit.

2. Carefully remove the media from the front tray.

3. Wall Mount: Remove the replace assembly from the

wall by carefully lifting it upward, releasing it from the

anges of the wall-mounting bracket. (Figure 4).

Pedestal Mount: Carefully lay the unit face down on a

at surface and remove the six (6) screws holding the

pedestal to the unit. (Figure 5)

4. Carefully set the unit upright on a at working surface.

NOTE: If necessary, lay a protective barrier between

the unit and your work surface, (i.e. cloth, cardboard, thick

plastic) to avoid scratching your work surface.

5. On the right end, with the controls, remove the seven

(7) screws around the outside of the end panel. (Figure

6. Remove the three (3) front panel screws along the

center of the back of the unit. (Figure 7)

7. Lay unit on its back and remove the remaining nine (9)

screws from the end panel.

8. Remove the end panel being careful not to add any

strain to the wires connecting to the controls.

9. Gently guide the partially reective glass out the open

side of the rebox.

10. Remove both sets of three (3) end panel screws and

the ve (5) front screws that hold the Media Tray in

place. (Figure 8)

11. Lay the unit on its back.

12. Remove the ve (5) screws that hold the LED light

bracket onto the bottom of the rebox. (Figure 10)

13. Remove the old LED light strip from the bracket, lay

the new LED light strip back into the light bracket and

secure with the original 2 screws.

NOTE: There are 2 LED strips in the DF1136, the

replacement is the same as the single replacement.

14. Trace the wires from the original LED light strip up to

the LED driver board, replacing them with the new

wires and any new tie wraps as required.

15. Remove and replace the wire connectors from the

terminals on the LED driver board.

NOTE: Use a at head screwdriver to gently pry

between the end of the connector and the switch to release

the wires.

16. Remount the LED light strip bracket onto the rebox.

17. Re-assemble the remainder of the replace in reverse