Service manual

9
the unit and your work surface, (i.e. cloth, cardboard, thick
plastic) to avoid scratching your work surface.
5. On the right end, with the
controls, remove the seven
(7) screws around the
outside of the end panel.
(Figure 5)
6. Lay unit on its back and re-
move the remaining nine (9)
screws from the end panel.
7. Remove the end panel being
careful not to add any strain
to the wires connecting to
the controls.
8. Remove the wires from the
On/Off switch noting the
original location of each one.
!
NOTE: Use a at
head screwdriver to gently
pry between the end of the
connector and the switch to
release the wires.
9. Squeeze the mounting tabs
located on the top and bot-
tom of the switch, to release
the switch and push it out through the side panel of the
replace. Note its original orientation in the opening.
!
NOTE: It may be helpful to use needle-nose pliers for a
better grip and squeeze the mounting tabs simultaneously,
then push the switch outward. Alternatively, a at head
screw driver can be used to press the each mounting tab
down individually and pushing the switch out, alternating
sides until the switch is released from its position.
10. Replace the original switch with the new switch, ensur-
ing the correct orientation.
11. Reconnect the wires according to their original congu-
ration.
12. Re-assemble the remainder of the replace in reverse
order from the instructions above.
CAUTION: Ensure that the remote control wire antenna
is placed so that it is not caught between any of the
screws or sheets of metal.
!
NOTE: Be sure that the anges on the end panel are
positioned on the interior of the outside panel of the re-
place.
SWITCHBOARD REPLACEMENT
Tools Required: Philips head screwdriver
Flat head screwdriver
Needle-nose pliers
WARNING: If the replace was operating prior to ser-
vicing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
ON/OFF SWITCH REPLACEMENT
Tools Required: Philips head screwdriver
Flat head screwdriver
Needle-nose pliers
WARNING: If the replace was operating prior to ser-
vicing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Remove the frame ller strip and carefully remove the
glass or trim assembly from the unit.
2. Carefully remove the media from the front tray.
3. Wall Mount: Remove the replace assembly from the
wall by carefully lifting it upward, releasing it from the
anges of the wall-mounting bracket. (Figure 4).
Pedestal Mount: Carefully lay the unit face down on a
at surface and remove the six (6) screws holding the
pedestal to the unit. (Figure 5)
4. Carefully set the unit upright on a at working surface.
!
NOTE: If necessary, lay a protective barrier between
Wall Bracket
Figure 3
Figure 4
To Remove
Figure 5
This screw is only
on the DF1136