Specification Sheet

EWA Series
Commercial
Fan-forced Heater
Engineered for outstanding performance
and dependable service.
Features
§ Built-in DPST thermostat with on/off rocker
switches for easier control
§ Terminal block provided for connection to
optional remote line voltage thermostat
§ Fan size and pitch are matched to the motor for
smooth, quiet operation
§ Exclusive rust free cast aluminum heating grid
provides superior performance and stores energy
longer by acting as a heat bank
§ Operates at a lower temperature than any other
heating element on the market
Applications
Offices | Reception Rooms | Entranceways |
Stairways
Specifications
Voltage - 120V, 208V, 240V, 277V
Wattage - Sizes ranging from 1000W to 4000W
Airflow
- 50 CFM – 1000, 1500, 2000W
- 100 CFM – 3000, 4000W
Color - Almond
Finish
- Polyester/epoxy powder coating resists fading
and abrasion
Construction
- Units are fan type and utilize the “Down Flow”
principle of heated air delivery
- Designed for recessed mounting within standard
16" stud centers and wall thickness
- Rugged 20 gauge steel construction
Heating
Grid
- The cast aluminum heating grid contains a nickel
chromium resistance wire which is insulated in
magnesium oxide and sheathed in a protective
tubular stainless steel sheath
- The entire tube is completely cast into an
aluminum molded form, deeply embedded and
completely safe
- The finned design increases the heat radiating
surface of the element, giving wider distribution of
heat at a safer, lower temperature than the heating
element of any other wall heater
Controls
- A precision snap action hydraulic thermostat is
included for positive temperature control when the
rocker switch is in the ON position
- The hydraulic capillary sensing element is located
in the room inlet air stream to provide accurate
temperature
- The thermostat ranges from 4ºC/40ºF (low) to
38ºC/100ºF (high)
Warranty - 1-year warranty on complete unit
Exclusive cast aluminum
element design