Installation Guide

Dimplex Fireplace XHD28L/XHD28G / XHD26L/XHD26G / XHD23L/XHD23G 7
Installation
Placement
1. The Dimplex Electric Fireplace does
not require any special venting.
Make sure there is clearance for air
circulation beneath the unit and at
least 1/2" behind it.
CAUTION: Do not install the replace
directly on carpet or similar surfaces which
may restrict air ow.
2. Install the unit in an opening with the
following minimum dimensions:
Model XHD28
A 27" (686 mm) wide
B 31-1/8" (587 mm) high
C 8" (203 mm) deep
Model XHD26
A 24-3/8" (619 mm) wide
B 18-1/2" (470 mm) high
C 8" (203 mm) deep
Model XHD23
A 21-1/2" (548 mm) wide
B 20" (508 mm) high
C 8" (203 mm) deep
Mounting
1. If applicable, carefully pour and
evenly distribute the supplied media
in the media tray of the firebox.
Media
Tray
2a. If installing into a Dimplex mantel,
align the front of the firebox
(without front glass installed) with
the front face of the mantel. Install
provided screws into the front
holes on the inside faces of the
firebox. The screw will line up with
a hole in the mantel, securing it in
place.
A
B
C
3. If installing the unit in an existing
fireplace opening, seal all drafts and
vents with a non-fibrous insulation
material to prevent any chimney
debris from falling onto the unit. Do
not install into an existing fireplace
opening that is prone to dampness.