Owner’s Manual Model DF3015 IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this fireplace. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.
Table of Contents Welcome & Congratulations. . . . . . . . . . . . 3 IMPORTANT INSTRUCTIONS. . . . . . . . . . 4 Fireplace Installation . . . . . . . . . . . . . . . . . 7 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Maintenance. . . . . . . . . . . . . . . . . . . . . . . 14 Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . 18 Replacement Parts. . . . . . . . . . . . . . . . . . . 21 Always use a qualified technician or service agency to repair this fireplace.
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: heater has malfunctioned, or if the electric fireplace has been dropped or damaged in any manner, contact Dimplex Technical Service at 1-888-346-7539. ① Read all instructions before using this appliance. ⑦ Do not use outdoors. ② The heater is hot when in use.
IMPORTANT INSTRUCTIONS inside. Do not use in areas where gasoline, paint, or flammable liquids are used or stored. ⑭ Do not modify the fireplace. Use it only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. ⑮ Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/ power strip). ⑯ Do not burn wood or other materials in the fireplace.
IMPORTANT INSTRUCTIONS CAUTION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Fireplace Installation WARNING: Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons. WARNING: Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Fireplace Installation deep. The viewing area is 30 ⅛ in. (765 mm) wide and 20 ⅛ in. (511 mm) high. The fireplace does not require any additional venting. (See Figure 1 for recommended installation clearances.) Mantel Installation Install the fireplace assembly into the mantel (refer to mantel assembly instructions). ! IMPORTANT: If not using a Dimplex mantel, the fireplace must be installed in an enclosure with the following MINIMUM internal/opening dimensions (Figure 1A). New Wall Construction 1.
Operation Figure 2 A B C WARNING: This electric firebox must be properly installed before it is used. Manual Controls The manual controls for the fireplace are located in the lower right hand corner (Figure 2). A. Main On/Off Switch Supplies power to the 3-Position Switch. B. 3-Position Switch • Remote (right position): The unit is operated with the remote control. • Flame (center position): The flame effect is turned on.
Operation temperature cutoff switch can be reset by unplugging the unit, waiting five (5) minutes and plugging the unit back in. CAUTION: If you need to continuously reset the heater, unplug the unit and call Dimplex North America Limited at 1-888-346-7539. Please have your model and serial number ready when calling. Remote Control The remote control has a range of approximately 50 feet (15.25 m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls).
Operation 4. 5. 6. 7. ure 2B) to the Remote position (right position). Press and hold the Initialization Button on the unit (Figure 2C). While holding the Initialization Button, press the Flame/Heat On/Off button or the Purifire™ On/Off button on the remote control. Release the Initialization Button on the unit. Press the Flame/Heat On/Off button to turn the Flame/Heat function on or press the Purifire™ On/Off button to turn the Purifire™ function on.
Operation Figure 4 - Remote Control Functions A. Room Temperature B. Set Temperature B C. Light Dimmer Control A D. Flame Speed Control E. Sleep Timer F. Purifire™ I G. Purifire™ On/Off K H. Flame & Heat On/Off M I. Temperature Down J. Temperature Up K. Dimmer Down O Q C D E F J L N P R L. Dimmer Up M.Flame Speed Down N. Flame Speed Up H G O. Sleep Timer Down P. Sleep Timer Up Q. Purifire™ Speed Down R. Purifire™ Speed Up ting for the Purifire™ is set at low speed.
Operation on a thermostat. Press the J or I buttons to adjust the set temperature. Once the desired set temperature is reached the heater will turn off. The heater will cycle On and Off to maintain the desired set temperature. Disable Heat If desired, depending on the season, the heater on the unit can be disabled. The unit will operate in the same fashion, with remainder of the controls. To Disable - Press J and O at the same time. The temperature setting on the remote will no longer be visible.
Operation the sleep timer digits. 3. Release the O button and the Q button. 4. Press the Initialization button on the unit (Figure 2C). 5. Press the H button on the remote. Your remote will now have a different frequency communicating with the fireplace. Maintenance WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons.
Maintenance light bulbs. Care must be taken when removing the log set as the log set contains LED’s and wires. To access the lower light bulb area: CAUTION: Allow at least five minutes for light bulbs to cool off before touching bulbs to avoid accidental burning of skin. 1. Slide fireplace out of mantel. 2. Remove four Phillips screws from right side of trim (Figure 6). 3. Remove trim. 4. Slide glass to right side of fireplace to remove (Figure 6). 5.
Maintenance ness. 11. Install the Log Set Assembly by placing the front, bottom edge of the Ember Bed in the track behind the control panel. Once in place, push down on the back edge of the Ember Bed until the rear tab snaps into place under the Mirror (Figure 7). ! NOTE: Ensure the Log Set Assembly is installed tightly under the back ledge to prevent light leakage. 12. Slide front glass back into position and attach trim.
Maintenance once a year. To clean the filter gently tap filter on a hard surface to dislodge any loose dirt or debris, and then clean with water. No soap or cleaning products are recommended. The filter size is 20 x 10 x 1 inches, rated at MERV 10. To replace filter: 1. Remove fireplace from mantel. 2. Filter can be accessed from the top rear of the unit (Figure 8). 3. Grasp filter and slide filter straight up. 4. Replace or clean filter.
Warranty Products to which this limited warranty applies This limited warranty applies to the following model of your newly purchased Dimplex electric fireplace DF3015 and to newly purchased Dimplex fireplace surrounds (mantels) and trims. This limited warranty applies only to purchases made in any province of Canada except for Yukon Territory, Nunavut, or Northwest Territories or in any of the 50 States of the USA (and the District of Columbia) except for Hawaii and Alaska.
Warranty by Dimplex or its authorized service representatives) or otherwise altered. This limited warranty does further not apply to defects resulting from misuse, abuse, accident, neglect, incorrect installation, improper maintenance or handling, or operation with an incorrect power source. ment is not commercially practicable or cannot be timely made, Dimplex may, in lieu of repair or replacement, choose to refund the purchase price for such product or part.
Warranty authorized dealer’s or service agent’s place of business and all labour costs. Such costs shall not be the responsibility of Dimplex. • • For surrounds (mantels) and trims for the period ending at midnight on the first anniversary of the date of first purchase, Dimplex will in its sole discretion either repair or replace such defective surrounds (mantels) and trims or part thereof without charge.
Replacement Parts Log Set Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0439070100RP Flicker Motor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3000240200KIT Heater Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2200490600RP Cutout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2300270310RP Main On/Off Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2800070700RP Remote Switch Board . . . . . . . . . . . . .
