User Manual

ManualsBrandsDimplex ManualsHeaters2kW Girona Glass Panel Wall Mounted Heater

Installation and Operating Instructions

INDGAUP7RG Issue 0

Girona Panel Heaters

Dimensions

(millimetres)

Model(s) Watt A B

GFP200 W 2.0kW 940 107

GFP200 B 2.0kW 940 107

Important Safety Advice

When using electrical appliances, basic precautions

should always be followed to reduce the risk of fire,

electrical shock, and injury to persons, including the

following:

IIMPORTANT – The wall bracket supplied with the

appliance must be used.

WARNING - DO NOT USE THIS HEATER IN THE IMMEDIATE

SURROUNDINGS OF A BATH, A SHOWER OR A SWIMMING

POOL.

IMPORTANT – If the heater is installed in a room

containing a bath or shower, it must be so installed that

switches and other controls cannot be touched by a

person using a bath or shower.

Do not use outdoors.

Do not locate the heater immediately in front of or below

a fixed socket outlet or connection box.

Do not cover the heater. Do not place material or

garments on the heater, or obstruct the air circulation

around the heater, for instance by curtains or furniture,

as this could cause overheating and a fire risk.

NEVER cover or obstruct in any way the heat outlet slots

at the top of the heater or the air inlet slots in the base of

the heater.

The heater carries the Warning symbol indicating

that it must not be covered.

WARNING – THE SURFACES OF THIS HEATER CAN BE HOT.

Momentary contact with any part of the heater should

not cause injury.

This appliance is not intended for use by persons

(including children) with reduced physical, sensory or

mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or

instruction concerning use of the appliance by a person

responsible for their safety. Children should be

supervised to ensure that they do not play with the

appliance.

Note that due care and consideration must be taken

when using this heater in series with a thermal control,

a program controller, a timer or any other device that

switches on the heat automatically, since a fire risk

exists when the heater is accidentally covered or

displaced.

If the supply cord is damaged, it must be replaced by a

special cord or assembly available from the

manufacturer or its service agent.

Fig. 1

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Electrical

WARNING – THIS APPLIANCE MUST BE EARTHED

The heater is fitted with a cable and plug. The length of flexible

cable type H05VV-F size 3 x 1.0mm

on all models.

General

The heater is designed for wall mounting on the wall bracket

supplied. It should only be operated when in the upright

position - see Fig. 1.

All models are splashproof to IPX4 standard and may be

used in bathrooms, however not in the immediate vicinity of

baths, showers, water connections, wash basins or

swimming pools.

Before connecting the heater check that the supply voltage is

the same as that stated on the heater.

Wall Mounting

IMPORTANT – The wall bracket supplied with the appliance

must be used. The heater should be positioned observing

the minimum clearances stated around the heater - see

Fig. 1.

DO NOT locate the heater immediately below a fixed socket

outlet or connection box.

1. Remove wall mounting bracket from the back of the

heater by depressing the spring latch at the top of

each bracket - see Fig. 2.

2. Fix the wall bracket securely to the wall through the

four screw holes provided.

3. Present the heater to the wall bracket, and engage

lower slots in the back with bracket.

4. Raise the heater to upright position and push the

heater onto bracket to engage top latch.

565

150

Min.

300 Min.

shelf

150 Min.

255 Min.

C D

GFP200W 800 300

GFP200B 800 300

Fig. 2

AUS/NZ

Summary of content (4 pages)

PAGE 1
AUS/NZ Installation and Operating Instructions Girona Panel Heaters INDGAUP7RG Issue 0 Dimensions shelf (millimetres) Model(s) Watt A B GFP200 W 2.0kW 940 107 GFP200 B 2.0kW 940 107 300 Min. A 150 Min. B 565 150 Min. Fig.
PAGE 2
‘x’ in Fig. 5) from the rear of the thermostat moulding using pliers and inserting them in the preferred holes to limit the slider movement. Operation Switching On the Heater (see Fig. 3) The controls are located on the right hand side on top of the appliance, lift flap to access the controls - see Fig. 3. The button marked ‘ ’ controls the electricity supply to the electronic thermostat. An indicator beside the ‘ ’ button shows when the unit is powered ‘ON’. ‘x’ Fig.
PAGE 3
Safety - Overheat protection For your safety this appliance is fitted with a thermal cutout. In the event that the product overheats for some reason, the cut-out prevents excessive temperatures on the product by cutting the power to the heater. Once the heater has cooled down, it will reset automatically, it will continue to cycle on and off automatically until the reason for overheating is removed. Cleaning WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER.
PAGE 4
Energy Saving Tips 2. Cooking Around half the energy used in the home is for heating and hot water, so using your heating system efficiently will not only help the environment, but also save you money! Use the right size pan for the food and cooker hob. Energy efficiency tips for heating and hot water Keep saucepan lids on - this enables you to turn down the heat. Boil water for cooking in a kettle. 1.