KENTON SUITE KTN20-AU In keeping with our policy of continuous product development, we reserve the right to make changes without notice. 8/54283/0 Issue 4 OCN:11789 The product complies with the Australian Safety Standards and the Standard Electromagnetic Compatibility.
1 2 4 3 A B C D E F G H A D C F G H E B
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE Important Safety Advice When using electrical appliances, basic precautions should be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: If the appliance is damaged, check immediately with the supplier before installation and operation. Do not use this appliance in the immediate surroundings of a bath, shower or swimming pool. Do not use outdoors.
Controls: See Fig. 4 Icon Display Power / Standby - A Function Sleep Timer B Flame Effect C f1 f2 fp Press once to turn the product ‘ON’. Press a second time to put the product into ‘STANDBY’ (When returning from ‘STANDBY’ mode the product will return to previous settings unless the product has been unplugged, in which case it will reset to factory settings) Press multiple times to change the ‘SLEEP TIMER’ in 0.5 hr increments from 0.5 hr to 8.0 hr before turning off.
Remote Control - See Fig. 4 The maximum range of use is ~ 5metres. NOTE: It takes time for the receiver to respond to the transmitter. NOTE: The reciever for the remote control is located in the display, aim the remote control in this direction when inputting commands. Do not press the buttons more than once within two seconds for correct operation. Battery Information - See Fig. 4 1.
Glen Dimplex Australia 8 Lakeview Drive, Scoresby, VIC 3179, Australia Glen Dimplex Australasia Ltd. 35 Harris Road, East Tamaki, Auckland New Zealand www.dimplex.com.au sales@glendimplex.com.au www.dimplex.co.nz sales@glendimplex.co.nz Ph: 1300 556 816 Ph: 0800 666 2824 Fax: 09 274 8472 Fax: 1800 058 900 © Glen Dimplex Heating & Ventilation. All rights reserved.
