Technical data

www.dimplex.de/en
28
2012
Brine-to-water heat pump in a compact design
Max. flow temperature 58 °C
Casing colour White (similar to RAL 9003)
Low temperature brine-to-water heat pump
Compact design
SIK 7TE
Heat pump for heating purposes for indoor installation with integrated WPM 2007 plus controller. The control panel is integrated into
a brown-red design screen and can also be used as wired remote control using the wall mounting set (special accessories MS PGD).
Integrated brine components enable direct connection of the heat source:
• Brine circulating pump (observe the free compression)
• Expansion vessel (8 l)
• Safety valve and pressure gauge
Sound-optimised through insulated metal casing and double vibration-isolated compressor. Integrated solid-borne sound insulation for
direct connection to the heating system. Economiser for high coefficients of performance (COP). Compact design with optional domestic
hot water preparation and integrated components for direct connection of an unmixed heating circuit (must not be used for bivalent
systems):
• Circulating pump (observe the free compression)
• Overflow valve and safety module
• Expansion vessel (24 l)
Soft starter (from SI(K) 9 upwards), integrated flow and return sensors; external sensor (standard NTC-2), dirt filter and large-capacity
breather (1½“) with micro air bubble deposition for brine circuit included in the scope of supply.
Lower operating limit heat source (heating operation) -5 °C ; Upper operating limit heat source (heating operation) 25 °C ;
Refrigerant R407C
Order reference Art.-no. Heat output 1 compressor /
COP at B0/W35
Connection voltage Width x Height x Depth
mm
Weight
kg
SIK 11ME 352990
11.7 / 4.2
1/N/PE ~230 V, 50 Hz
650 x 1115 x 680
191
SIK 16ME 353000
15.6 / 4 .0 203
SIK 7TE 352810
6.8 / 4.1
3/N/PE ~400 V, 50 Hz
179
SIK 9TE 352820
9.0 / 4.2 180
SIK 11TE 352830
11.7 / 4.2 191
SIK 14TE 352840
14.4 / 4.3 203
Heat output and coefficient of performance (COP) according to EN 14511 at B0/W35 .
With borehole heat exchangers, the free compression values in the device information are to be adhered to (max. heat exchanger depth at DN 32: 80 m)!
SIK 11ME 352990 4015627352995
SIK 16ME 353000 4015627353008
SIK 7TE 352810 4015627352810
SIK 9TE 352820 4015627352827
SIK 11TE 352830 4015627352834
SIK 14TE 352840 4015627352841
Heat pump for heating purposes - ground as heat source
Design tank for compact brine-to-water heat pump
Design built-under buffer tank
PSP 100E
Nominal capacity 100 l; in brine-to-water heat pump design to enable space-saving installation on top of the built-under buffer tank;
polyurethane insulation for minimal downtime losses (can be used for heating and cooling); 1½“ sleeves for immersion heaters
(up to CTHK 635); 1¼“ heating water connections; colour: white; brown red design screen.
Order reference Art.-no. Short text For device type Width x Height x Depth
mm
Weight
kg
PSP 100E 353360
Built-under buffer tank
SIK 7 - 14
SI 6 - 14TU
SIH 6 - 11TE
WI 10 - 14TU
650 x 550 x 653 54
PSP 100E 353360 4015627353367
Design domestic hot water cylinder
WWSP 442E
Nominal capacity 400 l, in brine-to-water heat pump design, bare-tube heat exchanger (internal), three supporting feet, steel cylinder
(special inside enamelling) with protection anode, polyurethane insulation with minimal standby losses (approx. 2.7 kWh/24 h), inte-
grated temperature sensor for connection to the heat pump manager, colour white, brown red design screen.
Order reference Art.-no. For device
type
Usable
capacity
l
Heat ex-
change
surface
m²
Con-
nection
heating
˝
Con-
nection
circula-
tion
˝
Connection
DHW
˝
Width x Height x
Depth
mm
Weight
kg
WWSP 442E 353370
SIK 7 - 14
SI(H) 20 - 30
353 4.2 1¼ ¾ 1 650 x 1660 x 680 187
The achievable hot water temperatures are dependent on the maximum heat output of the heat pump, the heat exchange surface and the volume
flow in the load circuit (dimensioned for max. hot water temperatures of 45 °C according to the project planning documentation). For heat pumps
with two performance levels, domestic hot water preparation is achieved with a compressor.
WWSP 442E 353370 4015627353374