User`s guide

Page 19
Section 6: Installation of the controller
The controller should be installed:
 In a place which is away from direct sunlight
and high humidity.
 On a flat surface to prevent warping of the
remote controller and damage to the LCD
screen.
 Where the LCD can be easily seen for
operation. (Standard height from the floor is
1.2 to 1.5 meters.)
 In a location where the cable can be fed
though the wall or to the surface of the wall
and attached in such a way as not to cause
snagging.
Mounting the controller
1. Remove the remote controller‟s base by inserting a
flat-tipped screw driver 2 to 3 mm into one of the gaps
at the bottom of the case, and twist to open as shown in
Figure 22.
2. Do not remove the protective tape or paper which is
fixed to the circuit board with-in the upper case.
3. Secure the base to a wall using the screws provided.
Do not over tighten the screws.
4. Connect the controller cable to the upper case and
route it so that it will not be pinched. Clip the upper
case in place on to the base unit on the wall.
Figure 22: Opening the controller case
The controller should be installed in a
location where it is possible for the
home owner to regularly check for
errors. The installer should tell the
customer to check the display
periodically for errors.
In the event of an error involving the
compressor the inline flow boiler will
back up the heat load which will have
higher running costs compared to the
compressor.