INSTRUCTION MANUAL Liberty 1.5kW Electric Fireplace Model: LBY15-AU For domestic household use only.
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/ OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your product for the first time and keep them in a safe place.
• Although this appliance complies with safety standards, we do not recommend its use on deep pile carpets or on long hair type of rugs • The appliance must be positioned so that the plug is accessible. • If the supply cord is damaged it must be replaced by the manufacturer or service agent or a similarly qualified person in order to avoid a hazard. • Keep the supply cord away from the front of the appliance.
WARNING: KEEP BATTERIES OUT OF REACH OF CHILDREN • Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns and potential perforation of the oesophagus. • If you suspect your child has swallowed or inserted a button battery immediately call the 24-hour Poisons Information Centre on 13 11 26 (in Australia) or 0800 764 766 (in New Zealand) for fast, expert advice. • Examine devices and make sure the battery compartment is correctly secured, e.g.
Exposed to the weather outdoors Near water If the power cable wires are frayed or cut Where small children may be left unattended No extension leads or power boards Where the power cable may be damaged On a slope or uneven surface Where there is risk of fire or close to a naked flame Where it may be damaged by chemicals Where there is a risk of interference by foreign objects This product is not made for DIY repair If there is a risk of water falling on the unit 5
Specifications Model no. LBY15-AU Colour/Finish White Wattage 1500 Heat Settings 2 Thermostat Control Yes Remote Control Yes Warranty Dimensions (w x d x h) 2 Years 1100w x 280d x 900h For greater precision, please always refer to the rating label placed on the product.
Setup General Information The fire incorporates a flame effect, which can be used with or without heat, so that the comforting effect may be enjoyed at any time of the year. To reduce heat loss and to prevent any chimney up draft affecting the operation of your stove fire, we recommend that the chimney flue is sealed off. Always ensure that the appliance is sitting on a level surface. Before connecting the appliance, check that the supply voltage is the same as that stated on the appliance.
Setup WARNING: FALLING OR TIPPING APPLIANCES CAN CAUSE INJURY OR DEATH OF YOUNG CHILDREN, PLEASE ENSURE CHILDREN DO NOT CLIMB, HANG OR STAND ON THIS PRODUCT. WARNING: THIS APPLIANCE IS PROVIDED WITH A TIPPING RESTRAINT. THIS RESTRAINT IS NOT A SUBSTITUTE FOR PROPER ADULT SUPERVISION. THIS RESTRAINT MAY PROVIDE PROTECTION AGAINST TIPPING FURNITURE. DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE. FAILURE TO DETACH THIS RESTRAINT BEFORE MOVING FURNITURE MAY RESULT IN INJURY AND DAMAGE.
Control Panel & Remote WARNING: FAILURE TO FOLLOW THESE OPERATING INSTRUCTIONS MAY RESULT IN INJURY AND/OR DAMAGE. Remote control The maximum range of use is ~ 9 metres. WARNING: It takes time for the receiver to respond to the transmitter. Do not press the buttons more than once within two seconds for correct operation. NOTE: The receiver for the remote control is located in the display, aim the remote control in this direction when inputting demands. 1.
Operation Operating Instructions Icon A B C D E Function Description Power Press to turn unit Off or On. Unit Off Press to turn everything Off. Press again to turn unit On with previous settings. Unit On Press to turn unit On with previous settings. - If the flame effect was On, the flame will turn on and the previous heat setting will be activated (On or Off). The display will show the current heater temperature setting and after 2 seconds displays the room temperature.
Operation User Modes: Mode Name /Description 0 Action (Actions cannot be input by remote control) 0 Change Celsius ( C) to Fahrenheit ( F) Press both Temp down ( ) and Temp up ( ) on the unit and hold until beep is heard and display flashes. (To revert back to Celsius repeat this action) Disable/Enable Heat Options Hold both Flame cycle ( ) and Heat cycle ( ), on the product, for 5 seconds, when the heater has been disabled the product will beep.
Cleaning Over time, dust can accumulate which can effect performance. It is recommended to clean the unit at least once a month. CAUTION: ALWAYS Turn the unit OFF and disconnect the appliance from the power supply before undergoing any cleaning and maintenance. The surfaces of the heater should be given an occasional wipe with a dry soft cloth. Do not use detergents, abrasive cleaning powder or furniture polish as this can damage the surface of the product.
Customer Care: 1300 556 816 customer.care@glendimplex.com.au www.dimplex.com.au Supplied by Glen Dimplex Australia 8 Lakeview Drive, Scoresby, Victoria, 3179 © Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Australia.
