Installation Guide

3
Power
Press to activate the current standby state (On/Off).
•Standby State On
Press to turn everything Off. Press again to active the
previous ame effect state.
•Standby State Off
Press to activate the previous ame effect state.
- If the ame effect was On, the previous heat setting
will be activated (High, Low, or Off).
- If the ame effect was Off, the previous heat setting
will be activated (High or Low).
Press again to turn everything Off.
Flame
Press to light the back log, grate log, and ember mat
(optional), and start the ame effect.
Heat
• Heat On
Press to set the heat to Low (indicated by 1 short
beep). Press again to set the heat to High (indicated
by 2 short beeps).
• Heat Off
Press to turn heat Off (indicated by 1 long beep).
NOTE: After the heater is switched off, the fan will
continue on for 60 seconds before turning off. The log
LEDs remain On when the heater is ON and the ame
effect is Off.
360
o
Light
Press multiple times to change the LEDs on the
sides and back of the unit from white ickering to
white solid to Off. (This feature is active only when
the ame effect is On.)
Brightness
Press multiple times to toggle the log set LEDs
!
OPERATION
RLG20
Manual Control
The manual controls for the Revillusion are located on the
right-front leg of the log grate.
Power
Press to turn the ame effect on and activate the
previous heat setting (Off, Low, or High). Press again
to put the unit in standby mode.
Heat
• Heat On
Press to set the heat to Low (indicated by 1 short
beep). Press again to set the heat to High (indicated
by 2 short beeps).
• Heat Off
Press to turn heat Off (indicated by 1 long beep).
NOTE: After the heater is switched off, the fan will
continue on for 60 seconds before turning off. The
log LEDs remain On when the heater is ON and the
ame effect is Off.
360
o
Light
Press multiple times to change the LEDs on the
sides and back of the unit from white ickering to
white solid to Off. (This feature is active only when
the ame effect is On.)
Brightness
Press multiple times to toggle the log set LEDs
through its four brightness settings.
Remote Control
The replace is supplied with a multi-function remote con-
trol.
The remote control has a range of approximately 30 ft (9
m). To operate correctly, the remote control must be pointed
toward the front of the unit.
!