ROTHESAY RSY20 08/35691/0 Issue 3 The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3 These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig.
Fig. 5 Fig. 5a Fig. 5b Fig. 6 Fig. 7 Fig.
Fig. 9 Fig. 10 Fig. 11 Fig. 13 Fig.
Fig. 15 Fig.
Dimplex OPTIMYST Basket Introduction Thank you for choosing this Dimplex electric fire. Please read this information guide carefully to be able to safely install, use and maintain your product. Important Safety Advice When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following: 1. OVERHEATING WARNING: In order to avoid overheating, do not cover the heater.
The water tank, sump, sump lid, tank cap and air filters must be cleaned once every two weeks, particularly in hard water areas. The appliance should never be operated if the lamps are not working. The lamps should be regularly inspected as described under ‘Maintenance’ and ‘Changing lamps’. The sump and the water tank in this product are treated with a biocidal product, Silver Biocide.
Switch ‘B’:- Press once to turn on the flame effect. This will be indicated by an audible beep. Although the main lights operate immediately it will take a further 30 seconds before the flame effect starts. Press again to give flame effect and half heat. This will be indicated by two beeps. Press again to give flame effect and full heat. This will be indicated by three beeps. Press again to return to flame effect only. This will be indicated by one beep. Press to put fire in to standby mode.
CHANGING LAMPS If the flame and smoke effect appears grey or colourless it may be that one or more lamps have failed. You can check for lamp failure as follows. 1. Leaving the flame effect on, lift out the fuelbed and water tank. 2. It should be possible to view the lamps with the nozzle in place and observe which one needs to be changed. 3. Put Switch ‘A’ in the ‘OFF’ position, and unplug the fire from the mains. 4. Leave the appliance for 20 minutes to allow the lamps to cool down before removing them. 5.
Additional Information AFTER SALES SERVICE Your product is guaranteed for one year from the date of purchase. Within this period, we undertake to repair or exchange this product free of charge (excluding lamps & transducer disc & subject to availability) provided it has been installed and operated in accordance with these instructions. Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this guarantee.
Troubleshooting Symptom Cause Corrective Action The flame effect will not start. Mains plug is not plugged in. Check plug is connected to wall socket correctly. Low water level. Check that the water tank is full and there is water in the sump. Low voltage connector not connected properly. (See Fig.5) Check that the connector is inserted correctly. (See Fig.
OPTIMYST is a trade mark of GDC Group Ltd. GDC Group Ltd. MILLBROOK HOUSE GRANGE DRIVE HEDGE END SOUTHAMPTON TEL: 0844 879 3588 FAX: 0844 879 3583 WEBSITE: www.dimplex.co.uk Republic of Ireland Tel. 01 8424833 SO30 2DF c GDC Group Ltd, All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex. A division of GDC Group Ltd.
