(SP4) SP420 (SP5) SP520 (SP9) SP920 08/19222/6 (UK) - Issue 6 Products comply with the European Safety Standard: EN 60335-2-30 and the European Standards for Electromagetic Compatibility (EMC) EN55014-1 / A2: 2002 and EN55014-2:2003 which cover the essential requirements of EEC directives 73/23 and 89/336
1 SP420 SP520 964 100 min. 100 170 SP920 1200 182 100 168 650 664 'a' 'a' 300 min. (600 recommended) 2 1010 min. min. A B 696 3 C 'a' 300 min. (600 recommended) 300 min.
8 7 9 SP520 SP420 SP920 b 10 10a SP420 a SP520 & SP920 X C A Y B 11 12 b a SP520 & SP920
Wall Fires Models: SP420, SP520 & SP920 IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE General features of remote control are: Important Safety Advice When using electrical appliances, basic precautions should be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: If the appliance is damaged, check immediately with the supplier before installation and operation.
This section provides step by step instructions for selecting a location and preparing the site to install the fireplace into the following: Existing Fireplace 1. Make sure that the fire is located on a flat surface. 2. Seal all draughts and vents to prevent chimney debris from falling onto the Fireplace Insert. Do not install into an existing fireplace that is prone to dampness. 3. Remove the fire front panel by following the steps as outlined in ‘Lamp Replacement’ sections. 4.
Lamp Replacement – SP520 & SP920 WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE REMOVING LAMPS. Warning - The lamps reach high temperatures during operation. For this reason, allow the lamps to cool down after switching off the appliance. The front panel will need to be removed in order to change lamps – see Fig. 12. Warning - The front panel is heavy and easily damaged. The front panel is supported at the top by the chassis and held tight by magnets at the top and bottom on the SP520 model.
Cleaning WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER. For general cleaning use a soft clean duster – never use abrasive cleaners. The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners. Recycling For electrical products sold within the European Community. At the end of the electrical products useful life it should not be disposed of with household waste. Please recycle where facilities exist.
Dimplex UK Limited Millbrook House Grange Drive Hedge End Southampton Hampshire. SO30 2DF UK customer help line 8.00am–5.00pm Mon-Fri and 8:30am-1.00pm Sat (October-March) Technical Services: Tel. 0845 600 5111 Fax. 01489 773053 e-mail technical.services@dimplex.co.uk Republic of Ireland Tel. 01 8424833 [c] Dimplex UK Limited All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex UK Limited.