Operating Guide

Operation
SWM3520
7215850100R00
www.c3furnishings.com
! NOTE: The heater
on your fireplace may
emit a slight, harmless
odor when first used.
This odor is a normal
condition caused by
initial heating of internal
heater parts and will not
occur again.
CUTOFF SWITCH
! NOTE: There is a
safety temperature
cutoff switch (cutout)
inside the heater. If the
heater overheats, the
cutout will shut off the
supply power.
It can be reset by
unplugging the unit
and waiting 5 minutes
before plugging the
unit back on.
CAUTION: If you need
to continuously reset the
heater, unplug the unit
and call technical service
at 1-888-346-7539.
Power ON/OFF
The Power ON/OFF button turns the fireplace ON and OFF.
The fireplace has a built-in memory function. When turned back
on, it starts at the last used settings, with the exception of the
timer function. If the fireplace is disconnected from the main
power source, it reverts to the default settings.
Flame Control
Pressing the Flame Control button turns the flames on and
lights up the ember bed. Press the Flame Control button
repeatedly to change the ember bed color by cycling through
the following options: (1) amber, (2) blue, (3) amber and blue
(4) color rotation. Fifth press turns the flames and ember
bed OFF [and when the heater is on only the flames will be
turned off].
3
4
5
2
1
1
2
3
4
5
6
The fireplace can be operated with the multi–function IR remote
control or from the control panel located on the right-hand side
of the unit. The remote control has an operating range of up to
4m / 13ft.
1. Power ON / OFF
2. Flame Control
3. Heat Control
4. Backlight Control
5. Timer Control
6. Digital Display
3
4
5
2
1
1
2
3
4
5
6
3
4
5
2
1
1
2
3
4
5
6
3
4
5
2
1
1
2
3
4
5
6