Owner’s Manual Model: SWM3520 CONSUMER SAFETY INFORMATION: PLEASE READ THIS MANUAL BEFORE INSTALLING AND OPERATING THIS APPLIANCE. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN A POSSIBLE ELECTRIC SHOCK, FIRE HAZARD, AND/OR INJURY AND WILL VOID THE WARRANTY. To view the full line of Dimplex products, visit www.dimplex.
Table of Contents Welcome...............................................................3 IMPORTANT INSTRUCTIONS...............................4 Specifications........................................................6 Installation.............................................................7 Operation............................................................14 Maintenance.......................................................17 Troubleshooting...................................................18 Warranty.
Welcome Please use our convenient online registration page to record your model and serial numbers for future reference at: www.dimplex.com/register Model Number AIR HEATER CHAUFFE-AIR CALENTADOR DE AIRE CAUTION VOLTS VOLTIOS WATTS VATIOS CAT. # № DE CAT. CAT. NO. CSA # ATTENTION XXXXX MADE IN CHINA FOR: / FAIT EN CHINE POUR: HECHO EN CHINA POR: SERIAL NO.
IMPORTANT INSTRUCTIONS Read this manual before attempting to install or use the electric fireplace. Always comply with the warnings and safety instructions contained in this manual to prevent personal injury or property damage. • Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire, or damage the fireplace.
IMPORTANT INSTRUCTIONS • Always connect to properly grounded outlets. • Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange the cord away from heavily trafficked areas, where it will not be tripped over. • Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or a relocatable power tap (outlet/power strip). • There is a resettable cutout switch inside the heater.
Specifications Electrical Voltage: Watts: Amps: Wiring: Bulb Type: Approvals: Dimensions 120VAC 60Hz 1400 Watts 12 A Plug-In LED SWM3520 Width: Height: Height with feet: Depth: Depth with feet: 36" (91.5 cm) 17-3/8" (44.1 cm) 20-1/8" (51.0 cm) 5" (12.8 cm) 11" (28.0 cm) Weight 25.9 lbs (11.
Installation GROUNDING INSTRUCTIONS • This product is equipped with a cord that has an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. • This heater is for use on 120 volts. The cord has a plug as shown. Grounding Pin • A 15 Amp, 120 Volt circuit is required. A dedicated circuit is preferred, but not essential in all cases.
Package Contents Tools required A B x4 x4 C x4 D x4 1 4 2 5 6 7 3 8 8 9
Installation WALL-MOUNT INSTALLATION 1 1 3 2 A x4 3 B x4 30 IN | PO | PLG (76.2 cm) 15-3/4 IN | PO | PLG MINIMUM / MÍNIMA (40.
Installation 3 3 1 Wall 4 5 1 10 6 7
Installation 5 2 1 C x2 Wall TABLE TOP INSTALLATION 1 8 D x4 11
Installation 2 Remove screw and save for step 3 3 9 Replace screw from step 2 12 C x2
Installation 4 5 6 7 1 2 5 1 C x2 Feet 13
Operation The fireplace can be operated with the multi–function IR remote control or from the control panel located on the right-hand side of the unit. The remote control has an operating range of up to 4m / 13ft. 1. Power ON / OFF 2. Flame Control 1 1 3. Heat Control 4 4 2 2 4. Backlight Control 3 3 5 5 5. Timer Control 6. Digital Display 6 5 4 3 2 1 ! NOTE: The heater on your fireplace may emit a slight, harmless odor when first used.
Operation 1 POWER ON/OFF The Power ON/OFF button turns the fireplace ON and OFF. 6 2 The fireplace has a built-in memory function. When the fireplace is turned back on, the display will show the last selected function and it will start at the last used settings (except5timer). If the fireplace is disconnected from the main power source, 5 it will restart at the default settings. 1 6 4 FLAME2CONTROL Pressing the Flame Control button turns the flames on and lights 3 up the ember 5 bed.
Operation Heater Enable & Disable Function: Press and hold the Heat Control button on the side of the fireplace for 10 seconds. The ember bed will flash five times to indicate that the heater is disabled. When the Heat Control button is pressed while the heat is disabled, the ember bed will flash but the heater will not operate. To enable the heater again, press and hold the Heat Control button on the side control panel for 10 seconds.
Maintenance • Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or household cleaners as these products will damage the metal trim. • The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater and air intake/output vents is recommended.
Maintenance Disposal of Used Batteries Batteries may contain hazardous substances that could be endangering to environment and human health. • This symbol marked on the battery and/or packaging indicates that used batteries shall not be treated as municipal waste. Instead they shall be left at the appropriate collection point for recycling. • By ensuring the used batteries are properly disposed of, you will help prevent potential negative consequences for the environment and human health.
Warranty One Year Limited Warranty Products to which this limited warranty applies This limited warranty applies to your newly purchased Dimplex electric compact insert. This limited warranty applies only to purchases made in any province of Canada except for Yukon Territory, Nunavut, or Northwest Territories or in any of the 50 States of the USA (and the District of Columbia) except for Hawaii and Alaska. This limited warranty applies to the original purchaser of the product only and is not transferable.
defective product or part without charge. If Glen Dimplex Americas is unable to repair or replace such product or part, or if repair or replacement is not commercially practicable or cannot be timely made, Glen Dimplex Americas may, in lieu of repair or replacement, choose to refund the purchase price for such product or part. • Limited warranty service will be performed solely by dealers or service agents of Glen Dimplex Americas authorized to provide limited warranty services.
Technical Service Contact our friendly customer service team for technical and trouble-shooting support. Make sure you have your sales receipt, location of purchase, and the model and serial number of your product. 1-888-346-7539 | www.dimplex.com/contact_us In keeping with our policy of continuous product improvement, we reserve the right to make changes without notice.
