Technical data

11..00 IINNTTRROODDUUCCTTIIOONN
11..11 BBUUIILLDDIINNGG RREEGGUULLAATTIIOONNSS AANNDD BBEENNCCHHMMAARRKK CCHHEECCKKLLIISSTT
Building Regulations (England & Wales) require notification of
the installation of a heating appliance to the relevant Local
Authority Building Control Department.
From 1 April 2005 this can be achieved via a Competent
Persons Self Certification Scheme as an option to notifying the
Local Authority directly.
CORGI operates a Self Certification Scheme for gas heating
appliances.
With the introduction of Self Certification Schemes, the
Benchmark L
ogbook is being withdrawn. However, a similar
document in the form of a commissioning checklist and service
interval record is incorporated at the back of these
instructions.
This company is a member of the Benchmark initiative and
fully supports the aims of the programme. Its aim is to
improve the standards of installation and commissioning of
central heating systems in the UK and to encourage the regular
serv
icing of all central heating systems to ensure safety and
efficiency.
Building Regulations require that installations should comply
with manufacturer’s instructions. It is therefore important that
the commissioning checklist is completed by the installer. The
relevant section of Building Regulations only relates to
dwellings. Therefore the checklist only applies if the appliance
is being installed in a dwelling or some related structure.
44
© Dimple
x Boiler
s 2008
11..22 IINNSSTTAALLLLAATTIIOONN,, CCOOMMMMIISSSSIIOONNIINNGG,, SSEERRVVIICCEE && RREEPPAAIIRR
This appliance must be installed in accordance with the
manufacturer’s instructions and the regulations in force. Read
the instructions fully before installing or using the appliance.
In GB, this must be carried out by a competent person as
stated in the Gas Safety (Installation & Use) Regulations.
DDeeffiinniittiioonn ooff ccoommppeetteennccee::
A person who works for a CORGI
registered company and holding current certificates in the
relevant ACS modules, is deemed competent.
In IE, this must be carried out by a competent person as stated
in I.S. 813 “Domes
tic Gas Installations”
No modifications or changes can be made to this appliance
without prior written permission from Dimplex Boilers.
The manufacturers instructions must not be taken as overriding
any statutory requirements. If in doubt contact Dimplex Boilers
on 0844 3711121.
WWaarrnniinngg --
Check the inf
ormation on the data plate is
compatible with local supply conditions.
All CORGI registered installers carry a CORGI identification card
and have a registration number. You can check your installer is
registered by telephoning 0870 4012300 or writing to:-
1 Elmwood
Chineham Business Park
Crockford Lane
Basingstoke
RG24 8WG
or check online at www.corgi-gas-safety.com
These appliances meet the requirements of;
Gas Appliance Directive 90/396/EEC
Efficiency of Hot Water Boilers Directive 92/42/EEC
Low Voltage Directive 92/42/EEC
Electromagnetic Compatibility Directive 92/31/EEC
Type test certified by:- Notified Body 0087 (Pin 87BT49).
P
roduct/Production certified by:
Notified Body 0086.
For GB/IE only